What Bladex Waste Valve has Male Connections on Both Sides and a 2" Diameter?
Updated 07/27/2026 | Published 07/22/2026
Products Featured in This Question
Question:
I need a bladex waste valve for rv holding tank 2in diameter with Male on both sides. Do you have if so what is the product number?
asked by: Mandi S
Expert Reply:
Hi Mandi,
It sounds like you need the Valterra Bladex Waste Valve for RV Holding Tank - 2" Diameter - Spigot to Spigot part # T1002A. The "spigot" connection is the threaded male connection you're needing, so the spigot-to-spigot is the correct connection for you. It's 2" in diameter passage allows wastewater to travel freely when valve is open and the 2" spigots slide into two separate sewer pipes.
Are you replacing a factory valve or a current Bladex valve?
Product Page this Question was Asked From
Valterra Bladex Waste Valve for RV Holding Tank - 2" Diameter - Spigot to Spigot
- RV Waste Valves
- Straight Valve
- Single Waste Valve
- 2 Inch Valve Body
- Manual
- 2 Inch Spigot
- Stationary Valve
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended SnapPad Jack Pads for a HWH Leveling System on a Motorhome
- Q&A: Can Furrion Chill Cube RV Air Conditioner Be Installed On A Bus Or Sprinter Van?
- Q&A: Replacement Screen Frame and Interior Trim for a VD0433 Roof Vent
- Article: Trailer Lighting Requirements
- Q&A: Recommended Replacement For A Fan-Tastic Vent Model 6504-414
- Q&A: Do You Have a Replacement Thermostat 15034 For an Atwood Furnace?
- Q&A: Replacement for Peterson 134-15 Series Clearance Lights
- Q&A: Replacement Lens for a Bargman 84 Series Trailer Tail Light
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: How to Measure for Motorhome Steps
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer