bing tracking image
Q & A Icon

Can I Splice A Nilight LED Tailgate Light Bar Into A Factory 7-Way Trailer Connector?  

Updated 07/10/2026 | Published 07/06/2026

Question:

Have a 2026 Hyundai Santa Cruz limited-have factory 7 pin harness installedround 7 pin connector female. Have Nilight 48 inch 80 leds turn-brake running lights with reverse light-with 4 pin flat connector with reverse wire4-7 pin modular block -USCAR connector with pigtails-Can I splice into existing OEM 7 pin connector remove splice wires from USCAR pigtails and 4 pin flat connector w/reverse wire ? Suggestions- thx

0

Expert Reply:

Hey Don, thanks for reaching out. Yes, you can do that. Since your 2026 Hyundai Santa Cruz Limited already has the factory 7-way, I'd splice the Nilight light bar into the factory wiring behind the 7-way connector instead of using the included 4-way and USCAR adapter. That'll give you a much cleaner installation while still keeping all of the trailer wiring functional. Just match the light bar's ground, running light, left turn/brake, right turn/brake, and reverse light wires to the corresponding circuits on the factory harness.

The only thing I'd recommend is making your connections with waterproof heat-shrink butt connectors or solder and adhesive-lined heat shrink so they'll hold up to the weather. Also, make sure the Nilight bar uses a combined stop/turn signal since that's what your Santa Cruz's 7-way provides. As long as it does, I don't see any issues with wiring it directly into the factory harness.

expert reply by:
0
Jesse M
Don S. profile picture

Don S.

7/10/2026

Okay thanks I going to connect the modular 4-7 pin with us car connector with pigtails and the nilight 4 pin flat To 4 pinflat with pigtails. Currently have a 7 pin to 4-5 pin adapter running the nilight 48 inch strip. Thx Don

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>