What Part Of MORryde Snap In RV TV Wall Mount Connects To TV
Updated 07/08/2026 | Published 07/03/2026
Products Featured in This Question
Question:
I have a 2020 Jayco trailer. It has one of your tv wall mounts in the bedroom and one outside. Its the part that mounts to the mall. What part mounts to the tv? To attach to the tv to the wall part.
asked by: Bill L
Helpful Expert Reply:
Hi Bill; I'm not sure if it is the MORryde Snap In RV TV Wall Mount # MR55ZR or # MR85ZR but both require a VESA mount on the back of the TV for installation. The plates seen below with the mounting pattern are the part you attach to the TV. If your TV doesn't have the VESA mounting holes on the back you will not be able to attach it to these wall mounts.
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
MORryde Snap In RV TV Wall Mount - Fixed - 35 lb Capacity - Steel
- RV TV Mount
- Wall Mount
- Fixed
- Steel
- 100 mm x 150 mm
- 200 mm x 100 mm
- 200 mm x 200 mm
- 300 mm x 300 mm
- 400 mm x 200 mm
- 400 mm x 400 mm
- Manual
- 35 lbs
- MORryde
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Swing, Swivel, and Tilt TV Wall Mount for a 25 lbs TV
- Q&A: Where to Find Key Number On RV Door Latch Lock If Key is Lost
- Q&A: What Does MORryde RV TV Wall Mount # MR65ZR Weigh
- Q&A: Replacement Lock for a Trimark 12054-37 Lock
- Q&A: Best Suspension Upgrade for 33" Tandem Axles: Road Armor vs Dexter EZ Flex for Ember 22ETS
- Q&A: Replacement Converter for PD9245C that is Lithium Battery Compatible
- Q&A: Magnetek 940 Recommended Replacement Converter
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
Bill L.
7/8/2026
The mount i have is a small plastic one. About 3 inches wide and 5 inches long. It has rounded grooves on top and bottom.i