Mounting Hole Pattern of B&B Square Corner Cap for RV Slide-Out # BM33ZR
Updated 06/24/2026 | Published 06/22/2026
Question:
What is the dimension on the screw hole pattern?
asked by: Steve
0
Expert Reply:
Hey Steve, each of the mounting holes on the B&B Square Corner Cap for RV Slide-Out # BM33ZR that you referenced are separated by 3-1/2 inches. That is from each hole center to the nearest hole center.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
B&B Square Corner Cap for RV Slide-Out - 5-1/8" - Polar White
- RV Slide Out Parts
- Caps and Covers
- Square Corner
- Bolt-On
- Black
- B and B Molders
more information >
Continue Researching
- Q&A: Looking for Replacement Stabilizer Jacks for RV Lippert 298707
- Article: Practice Safe Trailer Towing with These 4 Tips
- Q&A: Can Velit Diesel RV Heater Heat 288 sq ft Snowmobile Trailer
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Which Reese Goose Box Fits 2022 Fuzion 428 Toy Hauler
- Q&A: Is the Lippert 1621 an Extended Pin Box
- Q&A: Parts Needed for Installation of Onan Generator QG 7000i
- Q&A: Replacement Slide-Out Switch for 2004 Gulfstream Friendship G7
- Q&A: What Prevents Back Feed Into Solar Controller When Connected to Shore Power or Generator