Jack Foot Plate Dimensions for etrailer Trailer Jack
Updated 07/18/2014 | Published 07/17/2014 >
Question:
What are the dimensions of the foot pad? on the etrailer jack part # TJD-5000?
asked by: Lex
1
Helpful Expert Reply:
I went out into our warehouse and measured a Square Direct Weld Jack w/ Footplate # TJD-5000 and found that the dimensions are 7-1/2 inches long by 3-3/4 inches wide.
I included a video review of this jack.
expert reply by:
Chris O
1
Product Page this Question was Asked From
Square Direct Weld Trailer Jack w/ Footplate - Drop Leg - Topwind - 15-1/2" Lift - 3,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Topwind Jack
- 2001 - 3000 lbs
- Manual Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Brake Controller Install on 1997 Chevrolet Pickup
- Q&A: Comparing TruRyde 10-36 Grease and Dexter 10-63 Oil Seal
- Q&A: What Makes 5200lb and 6000lb Dexter Axles Different Capacity?
- Q&A: Compatibility of # LHCS102-SI60C Center Cap and # AM20906 Valve Stem with Dexstar Mini Mod Wheel
- Q&A: Stability of Bulldog Square A-Frame Jack # BD195318 When Faced with Shaking Horizontal Load
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Q&A: Replacement for a Triple Vision Backup Camera and Monitor
- Article: Trailer Tire Sizing
- Article: Trailer Lighting Requirements



