Does PowerMax RV Toilet # PM42VR Come with Flange Seal

Question

Question:

Does the PowerMax toilet come with the seal and everything to install?

asked by: Joe D

0

Expert Reply:

Hey Joe, yes the PowerMax RV Toilet # PM42VR that you referenced does come with a seal for the floor and everything else needed to install. I attached a picture that shows all of the hardware that comes with this as well.

expert reply by: Jameson C

0

Included Mounting Hardware
(click to enlarge)

Answer 1

Yes, it is James. The PowerMax 310 RV Toilet item #PM42VR is a Dometic 310 toilet. The PowerMax label is a high-performance flushing system featuring a powerful swirl-jet cleaning action. The PowerMax 310 RV Toilet item #PM42VR has a elongated seat…

view full answer...

Answer 2

Hey Steve, for your tongue weight of 600 lbs the Blue Ox SwayPro part #BXW0756 is rated correctly and would be a solid option for weight distribution. With that said for the money I would go with the Strait Line part #RP66083 instead as it has a much…

view full answer...

Answer 3

We do have replacement studs, but since we do not carry AL-KO products I am unsure as to a specific fit. I have attached a link that has our available list of replacement studs for you to look through. You will simply need to make sure that you check…

view full answer...

Answer 4

I spoke with my contact at Redline and he said that the Replacement Screw-In Wheel Stud, #25-53, is an industry standard grade 5. This replacement wheel stud will be equivalent to, or surpass, the load capacity of the old lug bolts that you are…

view full answer...

Answer 5

The part you referenced, Redline #25-53 Replacement Screw-In Wheel Stud, has a fine thread pitch and a 1/2-inch diameter. If this matches your trailer's wheel stud then you can use a lubricant to remove the old stud and replace it with this one…

view full answer...

Answer 6

Yes, you will want to use the Loctite Threadlocker 242 - Medium Strength - 1/4" to 3/4" Nuts/Bolts item #LT37418 to install the Redline Replacement wheel studs item #25-53. This is the blue one you will be able to remove your studs in the…

view full answer...

Answer 7

We have the Dexstar Conventional Steel Wheel, #AM20758, in stock so I went out to the warehouse to get an exact measurement for you. The outside diameter of the inner ring of this wheel is 11-1/2 inches including the nibs.

view full answer...

Answer 8

I went out into our warehouse to get the dimensions of the Dexstar Conventional Wheel part #Am20758 that you requested. From the opposite end of a nub to the other side of the round portion of the rim that sticks out this wheel measures 11-9/16…

view full answer...

Answer 9

I wasn't able to get exact info on your part number, but from the part number we know it's right hand thread wheel bolt like the part #RG02-020 which is a fine thread 1/2 inch diameter bolt with a 60 degree angled head. The other most likely…

view full answer...

Answer 10

The degrees represents the angle of the cone that is on the wheel bolt. If they are 90 degree then the cone is a 90 degree angle made by the angle created by each side of the bolt. A 60 degree lug bolt would have a 60 degree angle made by each sides…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Does PowerMax RV Toilet # PM42VR Come with Flange Seal

Product Page this Question was Asked From

Continue Researching