bing tracking image
Q & A Icon

Is There A Pre-Made Service Door For The Thetford Cassette Toilets?  

Updated 04/08/2026 | Published 04/07/2026

Question:

Hello, Im building a custom RV and was wondering if there is a pre-made door for this cassette toilet that I can install on the side of the camper to allow exterior access to the cassette? Also I see some toilets have a shroud to cover the interior part of the cassette, is that able to be purchased separately? I want the ceramic bowl that this toilet has but would prefer the back cover of the Thetford C223CS TH62YE and if I dont need to custom make a door Id be pretty happy with that as well.

0

Expert Reply:

Hello Graham, thanks for reaching out. Thetford does make a service door for their cassette toilets. Take a look at the following:

- Replacement Service Door for Thetford Cassette RV Toilets # TH43GA

This is designed as a replacement for a factory access door; you'd just have to measure your wall cut out and use the piece of wall material to complete the door assembly.

Where it gets a little tricky is the interior shroud. The version you’re looking at with the ceramic bowl and the C223CS style back cover aren’t mix-and-match pieces. That rear housing is built into the specific toilet model and isn’t sold as a separate add-on you can swap over.

What kind of rig are you building? Is it for off-grid boondocking or full-hookup parks?

expert reply by:
0
Jesse M
Replacement Service Door for Thetford Cassette RV Toilets
Replacement Service Door for Thetford Cassette RV Toilets
(click to enlarge)
Graham profile picture

Graham

4/8/2026

Off-grid boondocking 90% of the time. Mostly it'll be for solid waste. I considered an incinerator toilet but they were too expensive. I can fabricate something out of thin stainless sheet metal if needed for the inner shroud but if they had something I was able to buy made out of plastic that be preferable.

Jesse M. profile picture
Etrailer Expert

Jesse M.

4/8/2026

@Graham Ok cool! Yea there isn't a shroud piece available for that model so your best bet will definitely be to fabricate something. Let me know if there is anything else I can do to help!

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>