Is Drilling Required to Install the Curt Hitch part # C12123 on a 2014 Ford Transit Connect
Updated 07/08/2014 | Published 07/06/2014
Products Featured in This Question
Question:
do you need to drill holes
asked by: Ralph
0
Expert Reply:
You will not need to drill any holes in your 2014 Ford Transit Connect to install the Curt Hitch part # C12123. Check out the installation instructions I attached for this hitch as well.
For trailer wiring you would want the Curt Wiring Harness part # C56218.
For a ball mount you would want the part # C45521, pin an clip part # F-4, 2 inch ball part # A-82, 1-7/8 inch ball part # A-80.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- For Towing
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: Is etrailer Trailer Hitch a Good Option for a 2019 Ford Transit Connect
- Q&A: Can Curt Ball Mount Be Flipped Over To Achieve A Raise In Height
- Q&A: Parts Needed For Towing a Trailer With a 2016 Ford Transit Connect Titanium LWB
- Q&A: Will the Kuat Transfer V2 Bike Rack Work with a Backup Camera
- Q&A: Class III Trailer Hitch Fit on 2015 Ford Transit Connect with Long Wheel Base
- Q&A: 2 inch Lift Kit for Tandem Axle Fifth Wheel Trailer
- Q&A: Lift Kit Solution to Allow Fifth Wheel Trailer to Sit More Level When Towed
- Article: How to Choose the Right Trailer Hitch Class