Can the Curt Aluminum Ball Mount Be Flipped for a 5 Inch Rise or 6 Inch Drop?
Updated 11/14/2026 | Published 03/18/2026 >
Products Featured in This Question
Question:
I've got a pickup that sits pretty high, and my utility trailer needs at 5 inches of drop to ride level. I also occasionally pull a smaller trailer that sits higher. I'm looking at the Curt aluminum ball mount # C26PQ and wondering if I can flip it over depending on which trailer I'm pulling. Does it really give me both a 5 inch rise and a 6 inch drop, or am I misunderstanding how that works? And does it come with the hitch ball?
asked by: Darren
Expert Reply:
Hey Darren! Yes, the Curt Ball Mount for 2" Hitches # C26PQ can be used in either direction, giving you a 6 inch drop or a 5 inch rise depending on it's orientation. So if your utility trailer sits lower than your truck's receiver, you'd use the drop position. When you're pulling your smaller trailer with a higher coupler, you can flip it over for the rise.
The hitch ball isn't included, but if your trailer uses a 2 inch coupler, you need the 2" Stainless Steel Hitch Ball # SC23-C.
Personally, if I were pulling two different trailers on a regular basis, I would get the Rapid Hitch Adjustable Aluminum Ball Mount Kit # AM3411. It gives you up to a 5 1/2 inch drop or 6 1/2 inch rise, and it comes with two zinc plated hitch balls. That way, you can adjust the height to better match each trailer without removing the ball mount and you are not limited to just two fixed positions. It could make switching between trailers a whole lot easier.
Do both of your trailers use a 2 inch hitch ball, or are you switching between two different sizes?
Product Page this Question was Asked From
Curt Ball Mount for 2" Hitches - 5" Rise, 6" Drop - 8,000 lbs - Aluminum
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Aluminum Shank
- Drop - 6 Inch
- Rise - 5 Inch
- Fits 2 Inch Hitch
- 8000 lbs GTW
- CURT
more information >
Continue Researching
- Q&A: Best Trailer Hitch For 2005 Chevy Silverado 2500HD Pulling Two Horse Bumper Pull Trailer
- Q&A: Is Aluminum Ball Mount Compatible With Stainless Steel Hitch Ball For 2 Inch Hitch
- Q&A: How to Pick Out the Correct Rise/Drop Ball Mount to Tow Trailer Level
- Q&A: How to Wire Titan # T4748800 Reverse Lock-Out Solenoid Valve
- Q&A: Using a Hitch Extender to Keep Tailpipe Out of the Water when Launching a Boat
- Q&A: Recommended Way to Install Heavy Steel D-Ring Tie Down to Aluminum Floor of Car Hauler
- Q&A: Recommended Torque for Tightening Curt Hitch Balls to Ball Mount
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)

