Trailer Hitch that Fits 2027 Toyota Crown Signia Recommendation

Updated 03/23/2026 | Published 03/15/2026

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(38)

$236.66

Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector

(1781)

$84.64

Question:

will this hitch fit my 2027 Toyota Crown Signia? does it come with wiring?

asked by: Mark

Expert Reply:

Hey Mark, yes the Curt hitch part # C35MJ that you referenced is a confirmed fit for your 2027 Toyota Crown Signia. This is a really great hitch that is mostly hidden but it does not come with trailer wiring. For that you would need the Curt # C59236 for a 4-way harness. Are you towing a trailer?

expert reply by: Jameson C

Crown Signia Hitch
(click to enlarge)

Mark

3/15/2026

yes I have a little 5 by 8 I tow that has a 4-way

Jameson C.

3/15/2026

@Mark Nice! You'd be set with the two part numbers I mentioned then!

Pat M.

3/17/2026

This hitch works great for me. Towed a Uhaul 5x8 over 3000 miles without any problems at all. The wiring harness did require some splicing at the tail ights, but not a really big deal at all...

Rich R.

3/17/2026

@PatM Hi Pat, I ordered the hitch but haven't installed it. Looks similar to the hitch for my Venza which was a really easy installation I looked at the instructions for the wiring kit and the removing the lights to access wiring looks complicated and I'm worried about reinstalling them. Was that an issue? Thanks

Pat M.

3/17/2026

Rich, Removing the tail light assemblies wasn't difficult. Just remove the two screws and the use rubberized gloves to pull the light back away from the car. Once pulled you will find these connectors Drivers side white - running lights turquoise-turn signal flashers purple/white -brake Passenger side Black wire Running green flashers Grey brake You need to splice your harness connecting wires to the flasher lines on both sides. The toyota wires are very small gauge so I recommend soldering in the splice to ensure good connectivity. Takes a couple hours start to finish starting from scratch

Jameson C.

3/17/2026

@PatM That is really great info thank you for that!!

Jake

3/17/2026

Hitch works great on my Crown Signia . Took 20 minutes to install. Easy breezy.

James

3/23/2026

Bought and installed the hitch with just a little cutting of plastic. Pretty easy process. The wiring harness is a bit more of a challenge until you identift and locate the wires inside the trunk.