bing tracking image
Q & A Icon

Can Steel Light Mounting Box be Used to Mount Lights High Up On a 2004 Sunseeker Motor Home  

Updated 07/03/2014 | Published 07/02/2014

Question:

I want to add 2 tail/stop/signal lights up high on the rear of my motorhome for distant recognition in traffic. The lights are exactly 4 inches in diameter. The rear wall is 2 inches thick made of a plastic/vinyl looking material called azdul. I dont want to cut into that wall material to make a surface mount. It would be difficult to run the wiring through the wall and down to the trailer wiring connection on the inside so I plan to use a form of white raceway matching the corner molding already installed to hide the wires. I intend to mount the boxes at the outer left and right edges of the vehicle. Can the MT-BOX4 it be screwed to 2 inch adzul walls? Is there space for a 4 inch round light and a rubber grommet within the hole? Can I drill side wiring holes in the box? Do the boxes come in white? As it is steel, do you recommend covering the box with a rubber spray compound to control rust? Im in a cold climate ...... will that make a difference?

0

Expert Reply:

You would be able to tell pretty quick if the walls can support the lights and housing with just screws. Otherwise some type of anchor would be required like you would use in drywall.

The difficulty of running the wires to the desired location is going to depend on how much room there is behind the walls to route the wiring. Otherwise you could route it on the outside of the trailer and use something to protect the wires, like loom # 459075 painted to match the exterior of the trailer (if you wanted it to match).

The hole in the box # MT-BOX4 is 4 inches in diameter. The light with the grommet would be a tight fit, which is what you want, but if needed you could easily expand the hole as needed with a rotary tool. But that shouldn't be necessary.

You could drill holes for the light wiring where needed. Just use some silicone such as # 0160297 to seal up the holes around the wiring after installation to keep water out.

The boxes only come in black but could be painted with the appropriate color and type of paint for a steel structure. The paint should provide corrosion resistance but anything you can do to make it less susceptible to the elements certainly wouldn't hurt it any.

expert reply by:
0
Michael H

Product Page this Question was Asked From