bing tracking image
Q & A Icon

Can the Lippert Electric Ground Control TT Be Installed on a 2026 Alliance Delta 292RL Trailer?  

Updated 10/01/2026 | Published 01/17/2026

Question:

I have a 2026 Alliance Delta 292RL travel trailer and am wanting to install the Lippert Ground Control TT. The manual and videos I have researched says the front levelers need to be installed within 60” from the front of the camper I’m assuming they don’t mean the front of the tongue. My A-Frame extends up under my trailer about 62”, so I would be forced to mount it about 65” to 70” back from the front. Will this still work?

0

Expert Reply:

Hey Bob, congrats on the new trailer. The Lippert Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System item # LC672136 can indeed be installed on your 2026 Alliance Delta 292RL travel trailer. This is one of the automatic leveling systems offered as an option for your trailer.

Clearance is going to be more important than distance away from the tongue when installing the Lippert # LC672136 on your travel trailer. The jacks will stick down nearly 7" after installation which could effect the approach and departure angles depending on mounting location.

You will want to run a string from the bottom of the tires to the lowest part on the front and rear of the trailer, and make sure the jacks are not sticking down below the string. If they are mounted in a location where they hang below the string you will want to move them or they will contact the ground when going up or down steep inclines. This is going to be the best way to determine placement of your jacks.

I attached a diagram below along with the installation instructions so you can see how to measure for placement.

If you have any additional questions, go ahead and click on the box that says Add Comment and I'll be happy to answer them.


expert reply by:
0
Jerred H
Electric Ground Control
Electric Ground Control
(click to enlarge)
Jerred H. profile picture
Etrailer Expert

Jerred H.

2/10/2026

Hey Bob, how did the placement of the Lippert Ground Control TT work out on your Alliance Delta 292RL? Were you able to find a mounting spot that kept good clearance under the trailer? Your feedback could really help others setting up the same system.

Sean M. profile picture

Sean M.

10/1/2026

@JerredH Hey Jerred, Is there any further updates or material on this install? I have a 2026 Wolf Den RBHS I’m looking to install on. I was taking measurements and with the CH-7 chassis, it looks like the only place to mount the jacks would be an about 64-67 inches center behind the drawbar because of the frame on this chassis and how bar back it goes from the front Of the trailer. Would this be a big deal if I install? Is there any changes I can do to install the front sensor?

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>