How Are The Measurements Taken On The CE Smith Hanger Kit?
Updated 01/16/2026 | Published 01/15/2026
Question:
Where are the measurements being pulled on these? I believe I just welded these on backwards...
asked by: Dan
Expert Reply:
Hey Dan,
The measurements from this kit, # CES32WR, refer to the hanger height and shackle strap length. The front hangers in this kit are 3-1/4" tall. That measurement is taken from the top of the hanger to the center of the spring bolt hole. The rear hangers are the 1-1/4" from the top of the hanger to the center of the bolt hole. I will attach a photo that better shows this measurement below.
The shackle straps are going to be 3-1/8". What is making you think you welded them backwards?
(click to enlarge)
Product Page this Question was Asked From
Single-Axle Trailer Hanger Kit for Double-Eye Springs - 3-1/4" Front, 1-1/4" Rear
- Trailer Suspension Parts
- Hangers
- Camper
- Car Hauler
- Utility Trailer
- Double Eye Springs
- Single Axle
- CE Smith
more information >
Continue Researching
- Q&A: How do I Determine when My Equa-Flex Cushioned Equalizers Needs to be Changed?
- Q&A: How to Determine Correct Suspension Kit For Tandem Axle Trailer
- Q&A: Finding Replacement Axle for 2003 Karavan
- Q&A: What Are the Correct Replacement Leaf Springs for 6,000 lb Axle
- Q&A: Recommended 2,000 lbs Axle w/ a 72" Hub-Face-to-Hub-Face Measurement
- Q&A: How to Measure for a Replacement Axle, Hubs, and Leaf Springs for a Boat Trailer
- Q&A: Looking For Axle For Boat Trailer With Hubs And Springs
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Raise Your Travel Trailer Height
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How Long will the Axles Last on my Boat Trailer?
- Article: Double-Eye Trailer Suspension System Review
Dan
1/16/2026
Hi Nick, thank you for the response. Well when I went to attach my leaf spring to what I assumed was the front hanger, it didn’t fit inside. It does on what I thought was the back hanger. Is it safe to assume the shackle straps attach to the outside of the hanger? If this is the case, I’ve most definitely welded them on backwards.