What are the Hole Spacing Measurements for U-Bolt Plate TRTP300175
Updated 06/25/2014 | Published 06/22/2014
Question:
this part is listed for 1-3/4inch springs , but the spec drawing shows 1-13/16 center to center on bolt holes which would make the I.D. between bolt holes where the spring goes 1-5/16 which is narrower than the spring by 1/2 inch ?
asked by: Rick
0
Expert Reply:
I went out to the warehouse and pulled the U-Bolt Plate # TRTP300175 to take the measurements personally. I have included a picture showing the correct dimensions for you.
expert reply by:
Michael H
0
click to enlarge
Product Page this Question was Asked From
U-Bolt Plate - 3" Diameter, Round Trailer Axle - 1-3/4" Wide Spring - 1/2" Bolts
- Trailer Suspension Parts
- U-Bolt Plates
- Boat Trailer
- Snowmobile Trailer
- 5200 lbs - 7000 lbs
- Round Axle - 3 Inch
- 1/2 Inch Diameter
- TruRyde
more information >
Continue Researching
- Q&A: Recommended Gen-Y Hitch Executive Fifth-Wheel King Pin Box for a Lippert 1621/1621HD Bolt Pattern
- Q&A: What 7 Leaf Spring do I Need for My RV with Dexter 7,000 Pound Axle?
- Q&A: Is The etrailer e89FV Have The Same Specs as the Dexter 072-079-00 Spring
- Q&A: Width of Support Bar For Tongue Mounted Crossbar for Malone MicroSport Trailers
- Q&A: Do Lights of Greystone RV Fireplace Have to be On with Heater On
- Q&A: How To Measure Wet Bolts And Suspension Components On Tandem Axle RV
- Article: Spring Towing Readiness Checklist
- Q&A: Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box for 2020 Grand Design Momentum 350G
- Article: The Upgrades: Firestone Air Command Kits
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: The Basics: Firestone Air-Spring Kits
- Article: How to Raise Your Travel Trailer Height
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Accurately Measure Trailer Leaf Springs