What OD Snap Ring Post Does The Bulldog Bolt-Thru Swivel Trailer Jack BD29FR Mount To?
Updated 12/08/2025 | Published 11/16/2025
Question:
I am looking at your BD29FR. I am trying to utilize the existing welded on snap ring post on my trailer. What is the o.d. of the post this mounts on? Thanks,
asked by: Mike
0
Expert Reply:
Hello Mike, thanks for reaching out. The Bulldog Bolt-Thru Swivel Trailer Jack # BD29FR mounts to a 2.5" OD snap ring post, which is the standard size.
What kind of trailer is this going on?
expert reply by:
Jesse M
0
BD29FR
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Bulldog Bolt-Thru Swivel Trailer Jack - Bolt On - Sidewind - 10" Lift - 1,500 lbs - Gray
- Trailer Jack
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Standard Grade
- 1001 - 2000 lbs
- Manual Jack
- 22-1/4 Inch Lift
- Bolt-On
- With Wheel
- Bulldog
more information >
Continue Researching
- Q&A: What Is The Mounting Plate Bolt Spacing For The Dutton-Lainson Boat Trailer Jack DL22335
- Q&A: Availability of Trailer Jack with Outer Tube Diameter of 2 inches
- Q&A: Looking For Black Trailer Jack That Will Fit A 5" x 3" Frame
- Q&A: Replacement Mounting Bracket for a Dutton-Lainson Boat Trailer Jack DL22210
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Diameter of Mounting Bracket Hole on Round Snap Ring Swivel Jack
- Q&A: Bracket Mounting Hole Dimensions of Fulton Jack part # F27CR
- Q&A: Best Wheel and Tire for Trailer to Replace 4.80-12
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Best Boat Trailer Jacks
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Lighting Requirements
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
Jesse M.
12/8/2025
Hey Mike, did the Bulldog swivel jack fit your trailer’s snap ring post the way you needed? Your update could make it easier for the next person trying to match their jack to an existing post.