Fascia Re-Installation After Installing Draw-Tite 75528 on 2013 Buick Enclave

Updated 06/24/2014 | Published 06/20/2014

Products Featured in This Question

Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"

(1791)

$160.94

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(288)

$182.21

etrailer Ball Mount Kit for 2" Hitches - 7,500 lbs

(1375)

$93.54

Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector

(267)

$36.58

Question:

I want to add a hitch to my 2013 Buick Enclave but I want to be able to reuse the hidden fascia cover on the rear bumper. Do you offer any hitches that you can confirm this can be reused as a standard GM hitch would allow? Thanks.

asked by: Ryan

Expert Reply:

We offer two brands of 2-inch Class III trailer hitch for your 2013 Buick Enclave and both will install in the same spot on the vehicle's frame. Both hitches can be seen on the link provided; both share the same installation note that the fascia door panel must be removed for hitch installation and possibly cannot be reattached. We do not offer any hitch that avoids this potential requirement. You may be able to trim this panel satisfactorily in order to re-install it.

Of the three hitches offered I suggest the Draw-Tite # 75528 for its higher tongue weight capacity of 750-lbs (versus 500-lbs for the Curt hitch # 13424 you referenced. I've linked an installation video for your review.

If you need a trailer wiring harness for towing you can use the plug-and-play kit from Curt, part # C56245. For a handy towing kit you might consider the etrailer.com Ball Mount Kit # 989900.

expert reply by: Adam R