Can the Demco Cast Head Coupler be Welded on Instead of Bolted on for an Installation?
Updated 11/13/2025 | Published 10/20/2025
Question:
Can the bolt on A frame coupler be welded on at a later date without compromising the product
asked by: Robert M
Expert Reply:
Hey Robert!
Anything metal can be welded on, but you will need to remove some of the finish on the Demco Cast Head Coupler # DM37ZR in order to get a good weld. Just cover it back up with a finish of your choice and you'll be good to go!
I do recommend having someone do the work who has done this type of installation already. We definitely want to be careful when towing something (especially since this is rated for up to 10K!).
Was your previous coupler welded on?
Product Page this Question was Asked From
Demco Cast Head Coupler w/ Jack Hole - eZ-Latch - 2" Ball - A-Frame - Bolt-On - 10K
- A-Frame Trailer Coupler
- Standard Coupler
- 50-Degree Frame
- Bolt-On
- 10000 lbs GTW
- 2 Inch Ball Coupler
- Auto Latch
- 2-1/4 Inch Hole
- Standard Grade
- Demco
more information >
Continue Researching
- Q&A: What Grade Bolts to Install Demco A-Frame Cast Head Coupler
- Q&A: Difference Between 10K Demco eZ-Latch Couplers
- Q&A: How to Measure the Angle of Trailer A Frame To Determine if a 50 Degree A Frame Coupler will Fit
- Q&A: Will Goodyear Endurance ST225/75R15 Fit 2024 Winnebago Access 26RL
- Q&A: What Is The Angle For The etrailer A-Frame Trailer Coupler?
- Q&A: Demco 2" A-Frame Couplers Dimensions Requirements
- Q&A: Fold-Away Coupler Hinge Kit For a Trailer With a 3" Wide and 2" Tall Tongue
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Camping Tips for First-Time RVers
- Article: RV Pre-Departure Checklist
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Measure a Trailer Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
Jon G.
11/13/2025
Hey Robert, how did things go with welding the Demco A-frame coupler later on? Did the finish hold up well after you covered it back up? Your update could make it easier for others thinking about doing the same thing.