Looking For 2.5" OD/1.375" ID Seal For 2001 EZ Loader Boat Trailer
Updated 11/13/2025 | Published 10/16/2025
Products Featured in This Question
Question:
Hello, I am looking for some grease seals for my 2001 ez loader trailer. The hubs measure 2.5” and the spindle shaft is 1.375”. I am not having any luck searching the internet. Can you help? Thanks
asked by: Alan N
Expert Reply:
Hello Alan, thanks for reaching out. That is not a common seal size at all. We have a seal with a 1.38" ID part # BB60005 but the OD is 1.98" and that would be the closest thing we have. It sounds like your trailer might use an obsolete seal size. It might be possible to switch to a hub with a smaller OD.
Do you happen to know what bearings the hub uses? Or if you can see the casting number on the hub I might be able to look that up. Let me know and I am happy to look into it and see if we can offer a solution.
Product Page this Question was Asked From
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Single Lip
- 1.75 Inch I.D.
- 2.72 Inch O.D.
- Redline
more information >
Continue Researching
- Q&A: Does TecNiq Round Side Marker Light TN54TR Come with Grommet
- Q&A: Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Replacement Locking Door Latch for 1994 Wells Cargo Trailer
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Solution for Needing Replacement Wesbar Trailer Taillights 403348
- Q&A: Dexter EZ Flex Equalizers for 6,000 Pound Axles on a 2006 Heartland Bighorn 5th Wheel
- Q&A: Replacement Bearings and Seal for an Al-Ko 12K Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Most Popular Wheel Bearings
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
Jesse M.
11/13/2025
Hey Alan, were you able to find a grease seal that fits your EZ Loader trailer hubs? Once you check the bearing numbers or hub casting, I can help narrow down the right match. Let me know what you find so we can get you set up.