Will Andersen Trailer Jack Block AN99VR Work On A Trailer Jack With A Wheel?
Updated 09/30/2025 | Published 09/27/2025
Question:
Will this work on a boat trailer with a wheel jack? Total weight is approx 2k - 2,5k pounds. Thanks
asked by: AJ
(click to enlarge)
Expert Reply:
Hello AJ, good question, and nice boat! The Andersen Trailer Jack Block # AN99VR is really only intended to be used on a jack with a foot plate, or just a straight tube. If you used it with a jack with a wheel, there would not be much keeping the wheel stable on top of the block. So my fear is it might be too easy for the trailer to roll off the block. It might be fine if you are on perfectly level ground. If the ground is uneven though things could get sketchy.
Does the wheel on your jack come off with a pull pin? I don't see one in your picture but I can't quite tell for sure. Your best bet for using the leveling blocks would be to just remove the wheel. That would make things much more stable. If that is not an option you might consider replacing your jack with one with a foot or straight pipe.
Product Page this Question was Asked From
Andersen Trailer Jack Block - 4" Tall x 10" Wide
- Camper Jacks
- 5th Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Leveling Blocks
- Plastic
- 5001 - 6000 lbs
- 4 Inch Lift
- Andersen
more information >
Continue Researching
- Search Results: trailer bunk slides
- Q&A: Can I Use The Tie Down Bunk Slicks With a Fiberglass Boat
- Video: Caliber Boat Trailer Bunks and Slides Manufacturer Spotlight
- Search Results: trailer jack blocks
- Q&A: Looking For Bunk Slides For My 9000lb Boat
- Shop: Tie Down Bunk Slicks for Boat Trailer Bunks - 16" Long x 3" Wide - Qty 10
- Video: Review of Tie Down Boat Trailer Parts - Bunk Slicks Boat Trailer Bunk - TD59FR
- Shop: SnapPad SnapJack QD RV Stabilizer Jack Pads - Qty 2
- Shop: Tie Down Marine Slides for Boat Trailer Bunks - Fits Two 8' Long 2x4 Bunks - Black
- Q&A: Can There be Gap on Tie Down Marine Slides for Boat Trailer Bunks TD99FR if Used on Longer Bunks
- Q&A: Leveling Blocks to Replace Stromberg Carlson Base Pad
- Video: Review of Caliber Boat Trailer Parts - Marine Slides for Boat Trailer Bunks - CA46AJ
- Shop: Tie Down Marine Slides for Boat Trailer Bunks - Fits Two 8' Long 2x6 Bunks - White
- Shop: Tie Down Bunk Slicks for Boat Trailer Bunks - 17" Long x 1-3/4" Wide - Qty 8
- Shop: Tie Down Marine Slides for Boat Trailer Bunks - Fits Two 8' Long 2x6 Bunks - Black
- Shop: SnapPad StakPad Universal Leveling Block and Jack Pad for RVs and Trailers - Blue - Qty 1
- Video: Review of Tie Down Boat Trailer Parts - White Marine Modular Slides Boat Trailer Bunk - TD69FR
- Video: Review of Caliber Boat Trailer Parts - Marine Slides for Boat Trailer Bunks - CA26AJ
- Q&A: Replacement Trailer Jack Recommendation for Dutton-Lainson Jack on Ranger Trailer
- Q&A: Where is the etrailer Swivel Jack # MJ-1500B-DWL Manufactured?
- Article: How to Measure for Trailer Hitch Drop
- Shop: Trailer Hitch
- Video: How to Choose a Trailer Brake Controller
- Q&A: Hitch and Wiring for 2013 Lexus GX 460
- Search Results: trailer hitch
- Article: Rooftop Cargo Carriers
- Shop: Trailer Wiring
- Search Results: trailer wiring
- Video: Review of TowSmart Trailer Hitch - Custom Fit 2 Inch Trailer Hitch Receiver - TS98ZR
- Shop: Suspension Enhancement
on Camper Jacks
