Availability Of A-Frame Trailer jack With 1.5" Outside Diameter Tube
Updated 09/02/2025 | Published 08/15/2025
Products Featured in This Question
Question:
Do you have an A-Frame trailer jack with an outside sleeve diameter of 1.5in ? This is for a small 1984 Starcraft pop-up trailer with a tongue weight under 1000lbs
asked by: J
Expert Reply:
Hello J, thanks for reaching out. I went thru all of the A-frame jacks we carry and I am sorry to say we do not offer one with a 1.5" outer diameter tube. They are virtually all 2-1/4" OD tubes. The only exception is the Dutton-Lainson A-Frame Boat Trailer Jack w/ Wheel # DL74MR which has a 2" OD tube.
Honestly, you might have a really hard time finding a jack with a 1.5" tube. It just isn't common anymore. If you are needing a new jack, I recommend having a new support plate welded on like part # JSP-100. This will allow you to mount a standard 2-1/4" OD jack like part # 3370091260.
(click to enlarge)
Product Page this Question was Asked From
Dutton-Lainson A-Frame Boat Trailer Jack w/ Wheel - Sidewind - 15" Travel - 1,000 lbs
- Trailer Jack
- Boat Trailer
- Utility Trailer
- A-Frame Jacks
- Marine Grade
- 0 - 1000 lbs
- Manual Jack
- 15 Inch Lift
- Bolt-On
- With Wheel
- Dutton-Lainson
more information >
Continue Researching
- Q&A: 2 inch Outer Diameter A-Frame Trailer Jack Recommendation
- Article: Trailer Wiring Diagrams
- Q&A: 7-Way to 4-Pole Trailer Connector Adapter for 2013 Porsche Cayenne
- Q&A: A-Frame Trailer Jack With Wheel Attachment
- Article: How to Repair an RV Roof
- Article: Best Bike Racks for Electric Bikes
- Article: Trailer Lighting Requirements
- Q&A: Recommended Anderson Ultimate Hitch for a 2018 Ram 3500 w/ the Factory Puck System
- Q&A: Install Instruction Guide to Use for EcoHitch for 2024 Subaru Crosstrek
- Q&A: What Advent Air Conditioning Set-up do I Need for My 2018 Heartland Terry Classic V21?
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Replacement A-Frame Jack For Atwood Mobile Product Jack On Trailer With 2" Diameter Mounting Hole
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure Your Trailer Wheel Bolt Pattern
Jesse M.
9/2/2025
Hey J, did you decide to go with the suggestion of welding a new support plate to use a standard 2-1/4 OD jack? I'd love to know how it worked out for you, as it could help others in a similar situation.