What is the Measurement from the Cargo Tray Floor to Top of Wall on MORryde RV Cargo Slide Tray?
Updated 08/06/2025 | Published 08/01/2025
Question:
I see this cargo slide has a height of 6 5/8 inches I’m assuming that is from the bottom of the slide to the top of the outer walls of the tray can you tell me the measurement from the top of the tray walls to the tray floor where the cargo would sit?
asked by: Michael
Expert Reply:
Hello Michael,
Happy to get that measurement for you! Always looking for an excuse to go stretch my legs.
The measurement from the tray floor to the top of the tray wall on the MORryde RV Cargo Slide Tray - 36" x 26" - 1 Way Slide - 60 Percent Extension - 800 lbs # MR37FR is 3 1/2". I attached an image of the measurement as well.
What are you looking to put in the tray?
(click to enlarge)
Product Page this Question was Asked From
MORryde RV Cargo Slide Tray - 36" x 26" - 1 Way Slide - 60 Percent Extension - 800 lbs
- RV Cargo Slides
- Cargo
- Carpeted Floor
- 60 Percent Extension
- 26 Inch Wide
- 1 Way
- 36 Inch Long
- 800 lbs
- MORryde
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Cargo Tray for a Predator 5000 Watt Generator
- Q&A: Recommended Slide Out Tray for a Predator 5000 Inverter
- Q&A: Slide-Out Tray For a Generator with 24" x 34" Base Dimensions
- Q&A: Will Hellwig Adjustable Big Wig Rear Anti-Sway Bar Fit 2024 Ford F-350 4X4
- Q&A: What Rear Anti-Sway Bar do I Want for My 2021 Ford F-350 Super Duty with Single Wheel?
- Q&A: Recommended Sliding Cargo Tray For An Onan 5500 Generator
- Q&A: Rear Sway Bar Recommendation for 2024 Ford F-350 4WD
- Article: Converting Your RV Water Heater to Tankless
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: How to Replace or Install an RV Roof Vent
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
Michael T.
8/6/2025
Thank you so much for your time and assistance and the very helpful image you provided.!!!