When Replacing Hot And Cold Water Lines How Tight Should I Tighten The Swivel Snap Connector?
Updated 09/02/2025 | Published 06/30/2025 >
Question:
connecting Hot and Cold water lines, using 1/2foot swivel naps female connector to male tread on unit, How tight should I tighten? In other words, hand tight only or specific number of turns behind hand tight.
asked by: Jim P
Expert Reply:
Hey Jim,
When tightening that 1/2" swivel connector while replacing the hot and cold water lines you are going to want to hand tighten them down first. It is then recommended to take a wrench to tighten it and additional 1/4" after hand tight to get it snug by feel. That 1/4" additional turn is going to keep you from over tightening and potentially damaging the connector.
What rig are you replacing those lines on?
Product Page this Question was Asked From
Replacement Shower Valve for D&W Inc. Spray-Away RV and Marine Unit - 3-3/8" - White
- Accessories and Parts
- RV Showers and Tubs
- Spray-Away Unit Parts
- Shower Valves
- D and W
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Quick Connect Adapter For Replacement Hose for D&W Inc Self-Storing Spray-Away Unit
- Q&A: Depth of Replacement Shower Valve for D&W Inc. Spray-Away RV and Marine Unit
- Q&A: How Can I Replace Lippert Unity X1 Control Board Part 801171
- Q&A: Height Setting For B&W Companion In 2026 Ram 2500
- Q&A: Replacement Exterior Shower Parts for 2013 Arctic Fox 811 Truck Bed Camper
- Q&A: Availability Of Antenna Extender For Furrion Vision S+ Camera System
- Q&A: Troubleshooting Landing Gear Not Lifting 5th Wheel
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Trailer Wiring Diagrams
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How Your RV Water System Works: A Complete Newbie's Guide
- Article: 7 Facts About RV Antifreeze Every RVer Should Know


Nick S.
9/2/2025
Hey Jim, Did you have a chance to try tightening the connector with the additional 1/4 turn? I'm curious if it worked well for your setup, as it might help others with similar installations.