Recommended Hanger Spacing For Triple Axle Trailer Using E67SR Springs And TREQ1304 Equazlizer
Updated 06/10/2025 | Published 06/06/2025 >
Products Featured in This Question
Question:
Hello, I am building a triple axle dump trailer. I have this E67SR spring and new hanger kit with TREQ1304 equalizer. My question is what would be my hanger placement measurements?
asked by: Jarrod C
Expert Reply:
Hello Jarrod, thanks for reaching out. For that # E67SR and # TREQ1304 equalizer your hanger spacing should be right around 30". This is only a rough guideline though. The only way to truly know the exact hanger spacing for your trailer will be to mock up the suspension then weld them on as needed. 30" should be a really good starting point for that, but you may need to tweak it slightly.
Product Page this Question was Asked From
5-Leaf Slipper Spring w/ Hook End for 6,000-lb Trailer Axles - 27" Long
- Trailer Leaf Springs
- Slipper Springs
- 9/16 Inch Eye
- Nylon Bushing
- 6000 lbs
- 2 Inch Wide
- 5 Leaf
- 27 Inch Long
- Standard Grade
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Q&A: How To Determine The Correct Leaf Springs For A Gooseneck Trailer
- Q&A: Replacement for 31 Inch Slipper Springs on Small Trailer
- Q&A: Replacement for a Dexter 072-032-00 Slipper Spring
- Q&A: How To Convert Trailer With Slipper Springs To Double Eye Springs
- Q&A: Parts Needed To Convert Boat Trailer From Slipper Spring To Leaf Springs
- Q&A: 4-Leaf or 5-Leaf Springs 6,000 lb Double-Eye Springs to Replace 26 Inch 4-Leaf Springs
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Most Popular Wheel Bearings
- Article: Troubleshooting Brake Controller Installations
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer



Jarrod C.
6/10/2025
Thank you very much.