Distance From Hitch Pin Hole Center to End of Shank on Lock N Roll Articulating Trailer Coupler
Updated 09/12/2025 | Published 05/25/2025
Question:
What is the distance from pin hole to the end of the tubing?.
asked by: Agustin S
0
Expert Reply:
Hey Agustin, from the center of the hitch pin hole of the Lock N Roll part # 336TS510 to the end of the shank that goes into your vehicle's trailer hitch measures 2-3/4 inches.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Lock N Roll Articulating Trailer Coupler for 2" Receivers - Trailer Side - 11,000 lbs
- Accessories and Parts
- Trailer Hitch Ball Mount
- Hitch Mounted Coupler
- Lock N Roll
more information >
Continue Researching
- Q&A: Dimensions of the Lock N Roll Articulating Adjustable Hitch
- Q&A: Are Safety Chains Needed with Lock N Roll Articulating Hitch
- Q&A: Lock N Roll Hitch Assembly for 5 Inch Drop
- Q&A: Is There Lock N Roll Articulating Hitch that Fits 2 inch Hitch
- Q&A: What is Distance from Hitch Pin Hole to Retaining Pin of Lock N Roll Articulating Trailer Coupler
- Q&A: Choosing the Correct Rise/Drop for Lock N Roll Articulating Hitch
- Q&A: Are Articulating Hitches Safe and Better for Off-Road Use
- Article: How to Measure for Trailer Hitch Drop
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Determining Trailer Tongue Weight
- Article: Where to Position the Trailer Axle?
- Article: Trailer Lighting Requirements
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
Jameson C.
9/12/2025
Hey Agustin, did the 2-3/4 inch measurement from the hitch pin hole to the end of the shank work for your setup? I'm asking because knowing your experience could help others with similar needs.