Looking for a Repair Kit for My Fulton 7K Magnum Series Jack, What Would be a Good Replacement?
Updated 05/28/2025 | Published 05/21/2025
Products Featured in This Question
Question:
I need to find documentation and/or a repair kit for a Fulton Magnum Series Heavy Duty 7000 lb capacity jack. I dont have a P/N but there is a number on the label: 09 260 21.
asked by: Austin C
(click to enlarge)
Expert Reply:
Hello Austin,
We have been asked about this jack in the past and have confirmed with Fulton that there is no longer a repair kit for the Fulton Magnum series as it is no longer being made. I am all about repairing what I have, so I am sorry to be the bearer of bad news.
You could replace your 7K Fulton with the Bulldog Square Jack w/ Footplate - Drop Leg - Sidewind - 28-1/2" Lift - 7,200 lbs # BD180455.
What kind of trailer is this going on?
Product Page this Question was Asked From
Fulton Square, Fixed-Mount Marine Jack - Drop Leg - Sidewind - 30" Lift - 2,500 lbs
- Trailer Jack
- Boat Trailer
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Marine Grade
- 2001 - 3000 lbs
- Manual Jack
- 30 Inch Lift
- Bolt-On
- With Rectangle Foot
- Fulton
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Replacement Bevel Gear Kit for Fulton XP15 Marine Jacks - 1,500 - 2,500 lbs
- Shop: Replacement Rod and Nut for etrailer and Ram Square, Direct Weld Jacks - 12K
- Shop: Replacement Bearing for etrailer and Ram Square Jacks - 7,000 lbs
- Shop: LubriMatic Mini Grease Gun Kit with Multi-Purpose Grease
- Shop: Replacement Gear Kit for etrailer and Ram Sidewind Jacks - 2,000 lbs and 5,000 lbs
- Shop: Replacement Bevel Gear Kit for Fulton Jacks - 800 - 1,200 lbs
- Shop: Replacement 1/2" Plunger Pin Kit for Fulton Marine Jacks
- Search Results: trailer jack
- Q&A: Looking For Replacement 7-Way Plug With Double Prong Design
- Q&A: Will a Taller Drop Leg Fit Fulton 2.5K Square Fixed-Mount Marine Jack FHD2500
- Q&A: Does Grease Seal # 34823 Feature a Garter Spring
- Q&A: 12 Volt Accessory Circuit Relay Location in 2019 Ford F-250
- Q&A: Troubleshooting Weak Trailer Brakes That Won't Lock Up with Override Lever of Controller Slid
- Q&A: How Can I Replace Lippert Unity X1 Control Board Part 801171
- Q&A: Solution for Brake Actuator on 3-1/2" Trailer Tongue
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure a Trailer Axle
Austin C.
5/27/2025
The only broken part of the jack is the square bushing to hold the handle in place. Do you know of any repair kits that might contain a similar bushing that I might be able to use or modify?