Recommended Replacement Bearings for a Triple 7k Axle Trailer
Updated 10/30/2025 | Published 02/25/2025
Products Featured in This Question
Question:
I have triple 7000 lb axles on my trailer. I am looking to try to upgrade the outer bearings so they are more reliable. Realizing the inside measurement of the 02475 is the same as the 14125A it would seem to fit the axle but would not fit the hub as the outer bearing measurement and race are larger and wider. What if I changed the hubs to 8000 lb hubs...would that work? Thanks, Frank
asked by: Frank
Expert Reply:
Hey Frank, it sounds like you trying to use the Replacement Trailer Hub Bearing # 02475 with your 7k axles? If that's the case, then that would explain why they don't fit in your hubs - because they're for larger 8k axles. You'd need to use the Replacement Trailer Hub Bearing # 14125A which does have the same inner diameter, but is for smaller axles.
You also can't just swap the hubs out either with the larger 8k hubs without swapping the entire axle out. So, I'd recommend sticking with the bearings # 14125A mentioned above, which will fit your current hubs.
If there is something else I can do for you, please feel free to drop a comment and let me know!
Product Page this Question was Asked From
Ultra-Fab Ultra Scissor Jacks - 30" Lift - 13,000 lbs - Qty 2
- Camper Jacks
- 5th Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Scissor Jacks
- Steel
- 10001 lbs or More
- Manual Jack
- 30 Inch Lift
- Bolt-On
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Scissor Jacks For 2020 Gulfstream Vintage Cruiser Travel Trailer.
- Q&A: Weight Distribution Recommendation for 2026 Jayco Feather 19MRK
- Q&A: Adding Stabilization Jacks To Fifth Wheel Trailer That Uses Lippert 3.0 Ground Control
- Q&A: Best Way to Level a Class A Motorhome at a Curb
- Q&A: Solution for Scissor Jack Stabilization on 2024 Grand Design Momentum 31G
- Q&A: Adding Stabilizer Jacks to the Rear of a Fifth Wheel
- Q&A: Air Force One Air Jumper Kit For Spartan K2 Chassis.
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: What Do I Need To Tow A Trailer?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: RV Propane 101: How Does My RV's Propane System Work?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Measure for Trailer Hitch Drop
Jon G.
10/30/2025
Hey Frank, how did things go after you stuck with the 14125A bearings for your 7k axles? Your update could make it easier for others trying to match bearings and hubs on similar trailers.