How To Remove The Trim Ring On The LED Trailer Dome Light w/ Motion Sensor # 3375625338
Updated 11/03/2025 | Published 01/21/2025
Question:
how to take apart as to mount base? Ive pryed on the plastic and it dosnt want to come apart. Yes,l took out the 3 screws.
asked by: Marty
Expert Reply:
Hey Marty,
The trim ring of the LED Trailer Dome Light w/ Motion Sensor # 3375625338 will pop off. There's three clips on the trim ring that are extremely hard to get off by hand but can easily be popped off with a flathead screwdriver. I popped each one off a bit and then pulled the trim ring off. If you do just one and try prying it off it'll keep fighting you.
If you have anymore questions just let me know and I'd be happy to help.
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
LED Trailer Dome Light w/ Motion Sensor - Surface Mount - 2,200 Lumens - White Base - Clear Lens
- Trailer Lights
- Interior Lights
- Round
- Surface Mount
- LED Light
- 5-1/8 Inch Diameter
- White
- Buyers Products
more information >
Continue Researching
- Q&A: Replacing Ramp Springs On Featherlite Snowmobile Trailer
- Q&A: How do you Replace the Internal Housing and Foot Plate on the Pro Series Square Jack # PS1400850383
- Q&A: Replacement Gear Set for Pro Series 1400850383 and Bulldog BD190754 5K Capacity Trailer Jack
- Q&A: Is 3/4 Inch Plywood Floor Adequate for D-Ring Tie Down Anchors with Backing Plate for 3,000 lb Car
- Q&A: Recommendation to Convert Generator Power to 12V 7-way Trailer Connection
- Q&A: What Wiring Options Are Available To Power The Bulldog Powered Trailer Jack
- Q&A: Replacement For Atwood GC6AA/10E 6-Gallon Water Heater
- Article: How to Install E-Track in 3 Easy Steps
- Article: Most Popular Wheel Bearings
- Article: Cargo Tie-Down Methods
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Trailer Lighting Requirements
- Article: Finding the Right Electric Winch
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
Kate F.
11/3/2025
Hey Marty, how did it go getting the trim ring off the LED trailer dome light? Those clips can be tough to release, so I’m curious if the flathead screwdriver trick worked for you. Your update could make it easier for others working with the same light.