Replacement Gear Set for Pro Series 1400850383 and Bulldog BD190754 5K Capacity Trailer Jack

Question

Question:

do you have Pro Series 1400850383 8,000 lbs Replacement parts? I am looking for the Sidewind Gear Kit. If you do, could you please send me the link for it. Thanks

asked by: John

0

Expert Reply:

The Pro Series # PS1400850383 uses the same replacement gear set as the Bulldog # BD190754. The replacement gear set you need is part # BD500106.

I've linked to a video showing the typical rebuild procedure. The video shows a different jack, but the procedure for your Pro Series jack would be similar.

Simply use the provided link to purchase the replacement gear set.

expert reply by: Mike L

0

Answer 1

Once you remove the cover from the top of the jack you will see one pin, called the groove pin, going through the handle of the jack. That pin can either be pushed or pulled through the handle. Once that pin is removed the handle can slide out of the…

view full answer...

Answer 2

For the 6" oval hole in the Buyers Products Tail Light Mounting Box #337LB383SL you will need the PVC Grommet #a70gb and a Optronics LED Trailer Tail Light #STL72RB. A 3-Wire Pigtail #A45PB is needed for connecting to the light. The 2" hole…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Replacement Gear Set for Pro Series 1400850383 and Bulldog BD190754 5K Capacity Trailer Jack

Featured Help Information

Miscellaneous Media

Continue Researching