Why Do RV Motorhome Steps Require Running to a Keyed Power Source
Updated 11/17/2025 | Published 12/30/2024
Question:
Please tell me why my key has to be on for the door to activate the steps . I just had to replace a bolt that goes through the gear to the turn buckle but it worked correctly prior to that. It does not seem like I need this part but not sure. Thank you
asked by: Randy
Expert Reply:
Hey Randy, so the Lippert Module part # LC301702 that you referenced does require running to a keyed power source which means a circuit that only has voltage when the key of the vehicle is on. This is so that when the motorhome is on (engine running) the steps will go out when door is open and close when door is closed. When the RV is off it means they will extend when the door is open but won't retract when door is closed. This allows it to better serve your needs when using the door if the motorhome was parked or if you needed to briefly pop out of it.
Product Page this Question was Asked From
Replacement Control Module for Lippert Electric Coach Step
- Accessories and Parts
- RV Steps
- Control Module
- Lippert
more information >
Continue Researching
- Q&A: Wire Diagram for Lippert Power Steps for Troubleshooting Wiring and Power Module
- Q&A: Replacement LCI RV Step Module for 164889
- Q&A: Wiring Diagram for Coach Step
- Q&A: Replacement Parts and Wiring Diagram for Lippert Coach Steps
- Q&A: Replacement for SCS/Frigette Coach Step Controller Part 202-3230
- Q&A: Replacement Coach Step Module for 2006 Holiday Rambler Admiral
- Q&A: Do Any Of The ST145R12 Tire/Wheel Combos Come With Metal Valve Stems?
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: Trailer Wiring Diagrams
- Article: Best Bike Racks for Electric Bikes
- Article: How to Measure for Motorhome Steps
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
Jameson C.
11/17/2025
Hey Randy, how did things go after learning more about how the keyed power source affects the step operation on your motorhome? It’d be great to hear if the steps are now working the way you expected. Your update could make it easier for others troubleshooting the same issue.