Lift Kit Needed For A Grand Design Reflection 367BHS 5th Wheel Trailer

Updated 11/26/2024 | Published 11/24/2024

Products Featured in This Question

Torflex Lift Kit - Tandem Axle - 3-1/8" Lift

(750)

$277.94

Dexter Trailer Springs Over-Under Conversion Kit

(783)

$89.26

Question:

Hello, I have a grand design reflection 367bhs. We are looking to see if there is a product you recommend that we can lift/block our rv to accommodate the height of our truck. Hoping for a 2-3” lift if possible. Thank you

asked by: Ian S

Expert Reply:

Hi Ian,

We have a couple of options for lifting the height of the trailer but fitment of these kits will depend on a few factors. What is the year of your Reflection? Can check the axle tubes for the axle tag sticker, which lists the axle capacity and serial number? The # K71-725-02 lift kit you were looking at is designed specifically for #12 Torflex axles. Grand Design typically uses round axles so you likely wouldn't be able to use this lift kit.

If you have round axles you'll need to use a kit like the Dexter Trailer Springs Over-Under Conversion Kit # K71-385-00, which would increase the height of the trailer by the diameter of the axle tube plus the height of the spring stack.

Let me know what year it is and if you can get a picture of the axle tag and I'd be happy to narrow down the options to what would actually work.

expert reply by: Kevin C

Ian S.

11/25/2024

120237 Dexter 6600lb each. The year is 2022 Looks as the axle is already under the leaf springs. I’m in my iPhone and don’t see an option for sending photos Thank you

Kevin C.

11/25/2024

@IanS There isn't currently an option for pictures in comments yet but if you're saying that the axles are already under the leaf springs then you wouldn't be able to use this style lift kit. You would either need to go with taller hangers or use a Correct Track kit like # RR55QX to raise the trailer by 2". These Correct Track kits do have a couple of stipulations though: -Minimum required distance from I-beam to spring mounting hole on hanger: 2-5/8" -Works with 3" wide x 3-3/4" tall hangers or 3" wide x 5" tall hangers and leaf springs up to 2" wide - Does not work with MORryde CRE3000 equalizers.

Ian S.

11/25/2024

@KevinC Looks like I have cre3000. Hangers I guess are my only option? It looks like blocks can be used as the axles have a flat welded plate where the leafs attach with u bolts…

Kevin C.

11/26/2024

@IanS We don't offer any spacer block kits to fit between the leaf springs and axles at this time so taller hangers would be the only option we could recommend in this case. The flat plate welded to your axle tube should be your spring seat, which is has a hole for the bolt that holds the leaf spring stack together to slip through.