Cutout Size for Valterra RV Water Inlet
Updated 12/22/2025 | Published 10/12/2024
Question:
What is the hole cutout size for Valterra part A01-0177LFVP ?
asked by: Ken
0
Expert Reply:
Hi Ken; the hole cutout size for the Valterra RV Water Inlet # A01-0177LFVP is approximately 3-1/2".
expert reply by:
Robin H
0
Product Page this Question was Asked From
Valterra RV Water Inlet - City Water - 2-3/4" Metal Recessed Flange - Brass FPT
- RV Water Inlets
- City Fill Inlet
- Recessed Mount
- Metal
- Brass
- White
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Troubleshooting Solera Smart Arm Power Issues
- Q&A: Can I Run The Dometic RV Water Heater DMC74FR On Electric Only?
- Q&A: Need A Replacement G6A-8E Water Heater For RV.
- Q&A: Can A Gas/Electric Atwood/Dometic RV Water Heater Be Switched To Use Only Electric
- Q&A: Why Does The Valterra HydroFlush Need To Be Installed On The Top Of The Black Tank
- Article: Converting Your RV Water Heater to Tankless
- Q&A: Diameter of Valterra A01-0177LFVPFresh water flange
- Q&A: Replacement Rooftop AC Unit For a 2012 Jayco Jayflight 33RDLS With Coleman 48254A866
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Double-Eye Trailer Suspension System Review
- Article: Most Popular Wheel Bearings
Robin H.
12/22/2025
Hey Ken, did the 3-1/2 inch hole cutout size work for your Valterra water inlet? Knowing how it fit could help others working on the same setup.