How To Wire In The JR Products Single Slide-Out Momentary Switch # 37212295
Updated 12/22/2025 | Published 10/03/2024 >
Products Featured in This Question
Question:
Where is the ground on this switch? We need a ground, a power, and a motor. This is for a TV that slides up and down.
asked by: Gary T
Expert Reply:
Hey Gary,
The Single Slide-Out Momentary Switch # 37212295 is designed to be wired in the following manner:
Power from your battery will run to the bottom left terminal.
The positive wire for the motor will run to either Motor (+) terminal in the middle with a jumper wire over to the other Motor (+) terminal.
The negative wire for the motor will run to either Motor (-) terminal with a jumper wire over to the other Motor (-) terminal.
I'm willing to bet the red wire is likely your power in from the battery and the blue and green are your motor positive and negative. You could probably see which is which real quick with a multimeter # PT89ZR.
Product Page this Question was Asked From
Single Slide-Out Momentary Switch - On/Off/On - Black
- RV Slide Out Parts
- Controller Parts
- Switch
- Black
- JR Products
more information >
Continue Researching
- Search Results: slide out switch
- Search Results: slide out switch
- Shop: Single Slide-Out Momentary Switch - On/Off/On - Black
- Search Results: lippert schwintek slide~out systems rv slide out parts
- Video: Review of JR Products RV Fixtures - Momentary On Off On Switch - 37212295
- Shop: Single Slide-Out Momentary Switch - On/Off/On - 4-Pin - Black
- Shop: RV Designer Contoured Slide-Out Switch with Bezel - 20 Amp Continuous - Black
- Video: Lippert Slide-Out Switch Assembly Spec Review
- Q&A: Recommended Replacement Slide Out Switch For A 2006 Forest River Cherokee Travel Trailer
- Q&A: Replacement Rocker Switch for 2022 Alliance Paradigm 340 Control Panel
- Shop: Single Slide-Out Switch - On/Off - Black
- Shop: Lippert Slide-Out Switch Assembly - Black
- Q&A: Best Replacement For Older Dometic Duo Therm 57915.531 Ducted Single Zone AC System With Furnace
- Q&A: Wiring Diagram for the JR Products Single Slide-Out Switch
- Q&A: Replacement Slide-Out Switch for 3-Wire Setup
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: RV Fireplace Replacement for EF30B in RV
- Q&A: Replacement Key For a Latch Lock That Has a M315 on it
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips





Jameson C.
12/22/2025
Hey Gary, how did things go wiring the Single Slide-Out Momentary Switch for your TV lift? Did the multimeter help you confirm which wires were power and motor leads? Your update could make it easier for the next person working on a similar setup.