What Size Frame Does CIPA Comp II Rearview Boat Mirror # CM11081 Fit
Updated 05/27/2014 | Published 05/24/2014
Products Featured in This Question
Question:
Does this mirror fits frame up to 7/8inch or 1 1/4inch wide tubing? There is a conflict in the descriptions and specs. Please verify. Thx.
asked by: Jason
Expert Reply:
I spoke to my contact at CIPA and he said the Comp II Rearview Boat Mirror # CM11081 has an aluminum bracket that accommodates round or square windshield frames measuring from 1/2 inch to 7/8 of an inch.
If that size is not an option for you, you may be interested in our Suction Cup Rearview Boat Mirror, # CM11050. This mirror does not require a specific size to fit and can be mounted anywhere on your boat that has a smooth, clean surface.
Product Page this Question was Asked From
CIPA Comp II Rearview Boat Mirror - Convex - Windshield Mount - 11" Long x 4" Wide - White
- Boat Mirrors
- Boat Mirrors
- Convex Mirror
- Clamp-On
- 11L x 4W Inch
- White
- CIPA
more information >
Continue Researching
- Q&A: Black Rear-View Marine Mirror for Use on 1987 Nautique Ski Boat
- Q&A: Replacement Hub Drum Recommendation to Replace One with Grease Seal 10-36
- Q&A: Replacement Oil Bath Hub Drum for 8 on 6-1/2 Bolt Pattern on 8,000 lb Axle
- Q&A: Replacement Trailer Hub/Drum for Part Number 2420801
- Q&A: Replacement Hub/Drum for Lippert 8k Hub 2420801
- Q&A: What Gauge are the Wires on Optronics Wishbone 5-Way Trailer Harness?
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Q&A: Viewing Angle of the CIPA Sport II Side Mirror for PWC or Jet Boat Part # CM11160
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Best Boat Accessories
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)