Dexter 23-340-00 And 23-341-00 Hydraulic Drum Brake Assemblies Needed

Question

Question:

LOOKING FOR HYD/BRAKE BACKING PLATE DEXTER D023-340-00 AND D023-341-00 LOOKING FOR A UNIT WITH PARKING BRAKE. WHAT IS THE LESS PRICE ONE YOU HAVE? THAT HAS PARKING BRAKE THANKS JOE

asked by: JOE

0

Expert Reply:

Hey Joe,

For both you'll need the left hand assembly # DX79CR along with the right hand assembly # DX69CR. These have built-in manual parking brakes that you can attach a cable actuated lever # T2385200 to for an easier way to engage the parking brakes.

expert reply by: Kevin C

0

Answer 1

Hey Matt, it'd actually be the Dexter Hydraulic Trailer Brake #DX69CR for the right hand side, #T2351300 for the left hand side, or #T2351300-200 for the pair. These are going to be the exact same 023-341-00 and 023-334-00 brakes you're…

view full answer...

Answer 2

Hi Joe, For the Dexter Hydraulic Trailer Brake - Right Hand #DX69CR you'll need part #bp04-162. If you need the left hand assembly #DX79CR shoes as well then you would need part #bp04-164.

view full answer...

Answer 3

The correct set of replacement brake assemblies for your AxleTek 12 inch assemblies is the kit part #AKEBRK-7-SA that you referenced. This kit is a pair of left and right assemblies that are an exact match to what you have that are also self…

view full answer...

Answer 4

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 5

The MTI number on your 8-201 hubs is simply a casting number. It does not indicate any information about the hubs or have anything to do with the actual part number. I'm not surprised to hear you have different outer bearings between the two…

view full answer...

Answer 6

The only difference between single and dual servo hydraulic drum brakes is that dual servo will provide more force while in reverse than single servo. That said, it's not much and most really don't use their brakes a ton in reverse so single…

view full answer...

Answer 7

Your trailer must have free backing brakes if you have never used the surge brake actuating coupler reverse lockout. If you did not have free backing brakes, your brakes would most likely brake even if they didn't lock up when you back up because…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The closest option we have to replace your Atwood 82543 actuator is part #DM72VR, which is the item you referenced. However, this actuator doesn't have the lockout like your Atwood does. For a lockout use #T4748800 as an electric lockout. It…

view full answer...

Answer 10

Hey Steven! I don't have any specific information on parts for that tow dolly, and I wasn't able to find a parts list. However, it does look like it uses standard hub and drum assemblies. Is your current hub marked Dexter 8-247? In one…

view full answer...

Answer 11

For the Titan model 60 drum brake surge coupler the replacement master cylinder kit is part #T4395100. This includes the master cylinder, gasket, orifice connector, hardware and cover. I linked both review and installation videos to help you.

view full answer...

Dexter 23-340-00 And 23-341-00 Hydraulic Drum Brake Assemblies Needed

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching