Can the White Ends of the Yates Keel Roller for Boat Trailers # YR18244-165EC be Removed
Published 05/22/2014
Question:
I need an 18inch roller with a larger ID than 5/8. I need around 1.5. Im wondering if the white inner section is removable from the 5/8inch ID 18inch rollers you sell?
asked by: Ian
0
Expert Reply:
I went out into our warehouse and pulled a Yates Keel Roller for Boat Trailers # YR18244-165EC and after some careful prying with a slot screwdriver I was able to remove the white ends of the roller. Once removed the diameter of the hole of the roller is 1-3/8 inches, which is just an 1/8 of an inch shy of being 1-1/2 inches.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Yates Keel Roller for Boat Trailers - Super-Heavy-Duty Rubber - 18" Long - 5/8" Shaft
- Boat Trailer Parts
- Rollers
- Keel Roller
- 3-3/4 Inch Diameter
- Rubber
- 17-1/4 Inch Long
- Fits 5/8 Inch Shaft
- Yates Rubber
more information >
Continue Researching
- Q&A: Replacement for a Tie Down 70lc Brake Actuator
- Q&A: Recommended Keel Roller For Best Weight Capacity on Boat Trailer
- Article: Trailer Wiring Diagrams
- Q&A: What is the Measured Height of the Roller to the Mounting Plate
- Q&A: Replacement Actuator For Older Tie Down 70LC
- Q&A: Lug Nut Size for 1/2-20 Wheel Bolt
- Q&A: Dimensions of CE Smith Deep V Keel Roller Assembly CE10405G
- Q&A: Why Should Rubber Strip Be Installed With TracVan on 2008 Ford E-150 Van
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub