Recommended Lift Kit for a 2016 Lance 1995 Travel Trailer
Products Featured in This Question
Question:
I am looking at the response on the Lance Lift Kit found at https://www.etrailer.com/question-547522.html I have a 2016 Lance 1995. Which lift kit part number would work for that? Rick Arizona
asked by: Rick D
0
Expert Reply:
Rick, it looks like your 2016 Lance 1995 travel trailer has tandem axles and a GVWR of 5,700 lbs , which sounds like you have #10 Torflex axles. If this is correct, then # K71-707-02 would be the correct lift kit for your trailer.
This kit is going to give you a 2 5/8" lift and includes all the mounting hardware for install.
expert reply by:
Bryce D
0
Product Page this Question was Asked From
Torflex Lift Kit - Single Axle - 2-5/8" Lift
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Single Axle
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Availability of Lift Kit for Escape 17B Travel Trailer
- Q&A: What is the Difference Between the GE Refrigerators # GE48FR and # GE26FR? Which do you Recommend?
- Article: How to Raise Your Travel Trailer Height
- Q&A: Correct Lift Kit for a 2024 Rockwood Geo Pro G19FD w/ a Torsion Axle
- Q&A: Lift Kit for a 2016 Casita Spirit Deluxe
- Q&A: Will The Dexter Torflex Lift Kit # DX56CR Fit A Lippert Axle
- Q&A: How Much Amperage does the GE Profile RV Refrigerator w/ Freezer # GE48FR Compressor Pull?
- Q&A: Lift Kit Needed for Lippert Torsion Axle
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: Trailer Tire Sizing
Rick D.
8/30/2024
The 2016 axle mount will not work with this particular solution. The 2016 mounts to the *side* of the frame using a four-bolt plate. I would send you photos but there is no way to upload them here. Rick