1/2 PEX Adapter to Use with City Water Inlet # 37262135
Updated 08/18/2024 | Published 08/09/2024
Products Featured in This Question
Question:
Good morning. I need a basic, flush mounted water inlet like 37262135, but I need to go from there to 1/2 pex. which part would you recommend? Thanks.
asked by: Wade W
0
Expert Reply:
Hey Wade, we have a PEX adapter with the part # FL36VR that you can use with the City Water Inlet part # 37262135.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
RV City Water Inlet w/ Brass Check Valve - 1/2" FPT - Plastic Flange - Surface Mount - White
- RV Water Inlets
- City Fill Inlet
- Surface Mount
- 1-1/2 Inch Diameter Cutout
- 1-5/8 Inch Deep
- Plastic
- 2-7/8 Inch Diameter Flange
- Brass
- White
- JR Products
more information >
Continue Researching
- Q&A: Kwikee RV Replacement Step Motor For A 2003 Newmar Motor Home
- Q&A: Vent Cover Recommendation for Ventline Roof Part # VD0433
- Q&A: Replacement Part For Ventline Manual Roof Vents P/N VDO 433 & VDO 434
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: What Is The Quick Connect Size On The WaterPORT Overlander and Weekender RG33PR?
- Q&A: Replacement LP Gas Detector for a CCI 7770.2 / Pre Tell Detector
- Q&A: Need A Replacement City Water Hookup For A Nautilus System
- Q&A: Will Curt E16 5th Wheel Trailer Hitch w/Universal Install Kit Fit a 2015 Chevy Silverado 2500
- Article: Converting Your RV Water Heater to Tankless
- Article: Double-Eye Trailer Suspension System Review
Wade W.
8/12/2024
That's very helpful. To make sure I'm looking at this correctly, if I wanted a straight fitting instead of the 90 degree fitting (FL36VR), then I would use part number FL65VR to get the straight fitting that would take me from the inlet (37262135) to 1/2" PEX. Is that correct? Thanks for the information.