Clearance of MORryde Slide Tray MR99RR to Bottom of Tray
Updated 01/19/2026 | Published 08/06/2024
Question:
On the MORryde slide tray MR99RR, what is the dimension from the bottom of the slide tray to where it mounts. I want to know if it will be high enough to clear my opening edge without having to raise it.
asked by: Paul A
0
Expert Reply:
Hey Paul,
From where it mounts to the bottom of the tray is 1.45" (a hair over under 1-7/16") for the MORryde RV Generator Slide Out Tray # MR99RR.
I have added a diagram from MORryde showing the full dimensions of the # MR99RR for you.
expert reply by:
Kyle S
0
Dimensions of MORryde Tray MR99RR
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
MORryde RV Generator Slide Out Tray - 15-3/4" x 16-5/8" - 100 Percent Extension - 250 lbs
- RV Cargo Slides
- Generators
- Metal Floor
- 100 Percent Extension
- 16-5/8 Inch Wide
- 1 Way
- 15-3/4 Inch Long
- 250 lbs
- MORryde
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Best Theft Protection Lock for a Trailer Coupler w/a Angled Lip Past the Receiver?
- Q&A: Will The MORryde RV Generator Slide Out Tray # MR89RR Hold a Predator 3500W Inverter Generator
- Q&A: Recommended Cargo Sliding Tray For A Predator 3500 Watt Generator
- Q&A: Generator Slide Out Tray For a Preator 3,500 Watt Generator
- Q&A: Recommended Slide Out Tray for a Predator 5000 Inverter
- Q&A: Installation and Wiring of Trailer Roof Vent with 12V Reversible Fan
- Q&A: Recommended Flat Towing Parts for a 2026 Chevrolet Silverado 1500
- Article: 5 Products You Need For Your Next Camping Trip (2022)
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: The Best Electric Trailer Jacks of 2025
- Article: The Best Towing Mirrors
- Article: Best Hitch Cargo Carriers
- Article: Hard Tonneau Covers vs Soft Tonneau Covers
- Article: The 5 Best Trailer Drop Hitches You Can Buy
Samuel C.
1/19/2026
Hey Paul, did the 1.45-inch measurement on the MORryde slide tray give you enough clearance for your opening edge? Knowing how it fit could help others planning similar setups. Your feedback would be great for anyone checking clearances on these trays.