What Part of the Bumper Fascia Requires Trimming on a 2010 Volvo XC70 to Install a Trailer Hitch
Updated 05/16/2014 | Published 05/15/2014
Question:
By rear fascia do you mean rear bumper? or the lower silver piece on the rear bumper?
asked by: Robert
Expert Reply:
The fascia is the plastic bumper cover. The bumper is actually the structural support that sits behind the bumper fascia. I have attached the installation instructions that explains what trimming is required to install the Curt Trailer Hitch, # 13266, on your 2010 Volvo XC70. I have also attached a photo of the step that shows were to cut. showing where the fascia is trimmed when installing a trailer hitch on the Volvo XC70. As you can see, only the underside of the fascia is trimmed, so it should not be noticeable once the hitch is installed.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Installation Instructions for Curt Trailer Hitch 13266 for a 2008 Volvo XC70
- Q&A: Comparing Curt And Hopkins Wiring Harnesses For 2011 Volvo XC70
- Q&A: Wiring Harness for 2016 Volvo XC70 and Running a Wire to the Battery
- Q&A: Does Curt Trailer Wiring Have to be Powered by 2010 Volvo XC70 Battery
- Q&A: Does 2009 Volvo XC70 Need to Be Reprogrammed to Install Curt C56386 T-Connector
- Q&A: Recommended Class III Hitch and 4-Way Wiring Harness for 2015 Volvo XC70
- Q&A: Replacement Converter for a Parallax Series 7300 Model 7345
- Article: Types of Trailer Hitches: How and Why to Use Each
- Article: Roof Rack Information
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Rust Prevention
- Article: Trailer Hitch Balls
- Article: In the Market for a Teardrop Camper? You'll Want to Pay a Visit to Hyk Outdoors