Is Welding Required to Install the Tandem-Axle Trailer Hanger Kit # APT4 on a Trailer
Published 05/13/2014
Question:
Does the installation of this kit require welding?
asked by: Michael F
0
Expert Reply:
Yes, you will need to have a qualified welder weld on the hangers of the Tandem-Axle Trailer Hanger Kit # APT4 on your trailer.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Tandem-Axle Trailer Hanger Kit for Double-Eye Springs - 3-1/4" Front/Rear, 5-7/16" Center
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Tandem Axle
- Redline
more information >
Continue Researching
- Q&A: Can Brake Drum Be Added To etrailer e37YR 2K Axle With Idler Hubs?
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Correct Hanger Spacing for the Tandem-Axle Trailer Hanger Kit Part # APT4
- Q&A: Tandem Axle Hanger Spacing for Double Eye Springs 25-1/2 Inches
- Q&A: How to Determine the Distance for Mounting Trailer Spring Hangers on a Single Axle Trailer
- Q&A: Hanger Spacing Needed for 25-1/4" Leaf Spring on Single Axle Trailer
- Q&A: Ideal Leaf Spring Hanger Spacing for Tandem Axle Trailer Using # e34SR 6000 lb Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Raise Your Travel Trailer Height
- Article: Slipper Spring Trailer Suspension System Review
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers