Dexter Triangular Equalizer Kit With Wet Bolts And No Grease Zerk On Top of Equalizer
Updated 02/17/2026 | Published 06/22/2024
Products Featured in This Question
Question:
I have a Trailex CT7041HS open car trailer. I am wanting to install new equalizers and shackles. I am looking at your Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers - 1-3/4inch Wide Double-Eye Springs Item K71-448-00 My springs are 1-3/4-inch wide. I have no clearance for grease fitting above the equalizers. Do you have an equalizer without the grease fitting? My current shackles are 1/8-inch thick and bolts are 3-7/8-inch. How long are shackle bolts in this kit? I do not see an equalizer pivot bolt listed in the kit. Is it available? Thank you.
asked by: Randy
Expert Reply:
Randy, I have a couple routes you can go since the grease zerk on the Dexter Heavy-Duty Suspension Kit # K71-448-00 is not going to fit inside your hanger. We do have the Triangular Equalizer # TREQ310 but this comes with nylon inserts so you would need to swap them for Bronze # D014-077-00 if you wanted to have Wet Bolts # MR46ZR.
Otherwise you could use the Kit # K71-448-00 and swap out the standard pivot bolts which come with the kit for the Wet Bolt # MR92HR and Nut # MR85DR. The shackle straps on these are 1/2" thick and the length of the bolts used with the shackles are 3-1/4" long.
Product Page this Question was Asked From
Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double-Eye Springs
- Trailer Suspension Parts
- Suspension Kits
- Boat Trailer
- Snowmobile Trailer
- Double Eye Springs
- Tandem Axle
- Dexter
more information >
Continue Researching
- Shop: MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 2-1/4" Long Shackle Straps
- Search Results: uo12~016
- Shop: Curved Equalizer for 1-3/4" Wide Double-Eye Springs - 7-3/4" Long - 9/16" Center Hole
- Shop: CE Smith U-Bolt Kit for Mounting 5.2K to 7K, Round Trailer Axles - 7" Long U-Bolts - Zinc
- Shop: 4-Leaf Double-Eye Spring for 5,000-lb Trailer Axles - 25-1/4" Long
- Shop: Shackle Strap - 2-3/4" Long
- Shop: Replacement Wet Shoulder Bolt - MORryde Suspension Upgrade Kits - 9/16" x 2-15/16" - Qty 1
- Shop: Replacement Grade 5 Flange Lock Nut for MORryde Suspension Upgrade Kits - 1/2"-20 - Qty 1
- Search Results: flange nuts
- Article: Double-Eye Trailer Suspension System Review
- Q&A: How to Find if Dexter Heavy-Duty Suspension Kit Will Fit on Trailer
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Difference Between Dexter Heavy-Duty Suspension Kit K71-448-00 & K71-359-00
- Q&A: Replacement Landing Gear and Equalizers for a 2008 Keystone Cougar 5th Wheel
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Recommended Cushioned Equalizer Replacement Options For Factory Equalizer 6" Wide and 4" Tall
- Q&A: How To Measure Wet Bolts And Suspension Components On Tandem Axle RV
- Q&A: Effect of Installing Shorter Shackle Straps on Trailer with Axle Over-Under Kit
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Dexter Heavy Duty Greasable Shackle Kit Needed
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Raise Your Travel Trailer Height
- Article: How to Tell the Weight Rating of a Trailer Axle
Jesse M.
2/17/2026
Hey Randy, how did things go with the suspension setup on your Trailex trailer? Did the equalizer and shackle combo you chose fit better with your hanger clearance? Your update could make it easier for others working with the same trailer design.