Recommended Replacement Slider Door Panel for a Lippert Entry Door
Updated 06/07/2024 | Published 06/01/2024
Question:
Hello, I have a Lippert door entry door with built in screen door and the screen door plastic slider stop broke on the door. I think one of my kids slid it too hard and broke it. Is there a replacement product for this slider stop that you are aware? thanks
asked by: Robert P
Expert Reply:
Robert, it sounds like you might be looking for the Lippert Screen Door Slider Panel with Push-Down Knob Opener # LC239061. This will work with Lippert doors that have a hinge on the right side, measures 9-3/4" tall x 12" wide, and is made in the USA.
If you're looking for something else, let me know or send a picture in and I'll be happy to see what we have.
Product Page this Question was Asked From
Lippert Screen Door Slider Panel with Push-Down Knob Opener - Clear
- RV Door Parts
- Screen Door
- Slides
- Clear
- Lippert
more information >
Continue Researching
- Q&A: Looking for RV Door Hinge Assembly
- Q&A: Is There Replacement Screen for RV Screen Door?
- Q&A: Will A New R32 AC Unit Work With Old R410A Controllers?
- Q&A: Comparing 4.80-12 and 155/70R12 Tire Dimensions
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Replacement Circuit Board For Dometic Atwood Water Heater With Circuit Board 91346
- Q&A: Lippert Smart Jack LC643589 - Is The Button Replaceable?
- Q&A: Correct Slide-Topper Awnings for 153.5" and 83.5" Slide Outs
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: Trailer Wiring Diagrams
- Article: Roadmaster Vehicle Specific Base Plates
- Article: How to Replace or Install an RV Roof Vent