Can a Keel Roller For a 10" Bracket Be Cut Down and Used In Place Of a 9" Roller?
Updated 05/29/2024 | Published 05/24/2024
Question:
I have a 1986 Boat Trailer that has 3 9 long x 5/8 dia Keel Rollers that need replacement. Can a 10 Keel Roller be cut down w/ bandsaw and s sleeves be reed to achieve the 9 Keel Roller OAL I need?
asked by: David L
Expert Reply:
First David, just to be sure if you are going to need to cut down the Yates Keel Roller for Boat Trailers # YR10000 you will want to measure the width of your mounting brackets. This particular roller is 9-3/4" wide and designed to fit a 10" wide roller. As your trailer is older the rubber can shrink slightly over time and you may not need to cut the roller. If you do need to cut the roller down slightly do be sure to remove the end caps on this particular roller first as they will need to be reinserted after you cut down each side.
Product Page this Question was Asked From
Yates Keel Roller for Boat Trailers - Heavy-Duty Rubber - 10" Long - 5/8" Shaft
- Boat Trailer Parts
- Rollers
- Keel Roller
- 3-3/8 Inch Diameter
- Rubber
- 9-3/4 Inch Long
- Fits 5/8 Inch Shaft
- Yates Rubber
more information >
Continue Researching
- Q&A: Roller Shaft Dimensions for a 10" Keel Roller
- Q&A: Replacement Marker Lights for Furrion F0S04TDE-RD/SY Lights
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Different Size Equalizers on Triple Axle Trailer
- Q&A: Roller Shaft Replacement for 10 Inch Yates Roller
- Q&A: Picking Out 10 inch Roller Setup for Boat Trailer With End Caps
- Q&A: Replacement Braking Assembles for an AL-KO 7,200 lb Axle
- Q&A: Replacement Hub/Drum for AL KO 7,200 lb Trailer Axle
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Lighting Requirements
- Article: How to Determine Tire/Wheel Diameter
- Article: How to Measure a Trailer Axle
- Article: How Much Solar Power Do I Need For My RV?
- Article: Testing Trailer Brake Magnets for Proper Function