Can You Take Apart Waste Valves From Double RV Waste Valves T81
Updated 05/28/2024 | Published 05/23/2024
Question:
Can I take these apart the 4 bolts holding the valve and reassemble without damage? I need to replace a coupling further back, and it looks like it may be easiest to disassemble at the valve so I can slide the grey side back and slip the new coupler on. Hope that makes sense! Thank you
asked by: Bryan K
Expert Reply:
Hey Bryan,
Yes, you can take apart the bolts holding the two valves together on the Double RV Waste Valves - Elbow - Rotating - 3" and 1-1/2" Hubs to 3" Spigot # T81.
The actual valve portion is meant to be replaceable so taking them apart is essentially the same thing (without replacing the valve, of course).
Product Page this Question was Asked From
Double RV Waste Valves - Elbow - Rotating - 3" and 1-1/2" Hubs to 3" Spigot
- RV Waste Valves
- Sewer Elbow
- Double Waste Valve
- 1-1/2 Inch Valve Body
- 3 Inch Valve Body
- Manual
- 1-1/2 Inch Hub
- 3 Inch Hub
- Rotating Valve
- Valterra
more information >
Continue Researching
- Q&A: Will 4.25 inch Diameter Center Cap Fit on Trailer Wheel # AM20535
- Q&A: Replacement Double RV Waste Valve For a 2015 Nucamp 320s Camper
- Q&A: Double Waste Valve with 3 inch and 1-1/2 inch Hub Fittings On Both Ends
- Q&A: Difference Between Valterra # T81, # T81A, and # T81B Double RV Waste Valves
- Q&A: Rubber Gasket for Replacement Light Lenses
- Q&A: Replacement Converter for WFCO WF-8955PEC for Lithium Batteries
- Q&A: Availability Of Replacement For RV Designer T517 Baggage Door Lock Without Plunger
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Best 5th Wheel to Gooseneck Adapters (2023)
- Article: Most Popular Wheel Bearings
Bryan K.
5/28/2024
Thank you!