SnapPad Fits for a 2011 Itasca Ellipse 42QD with HWH Jacks
Updated 05/03/2024 | Published 05/02/2024 >
Products Featured in This Question
Question:
2011 Itasca Ellipse 42QD Front jacks appear to be 10, rear 22, HWH system. Looking for all 4
asked by: Barry J
0
Expert Reply:
Hi Barry, thanks for reaching out!
For your 10" HWH plates you can use the Replacement Pad for SnapPad Jack Stand Pad System # SP64FR but you'll need to get 2 of them since it's sold in a quantity of 1.
We don't have any pads for a 22" round plate but just in case you meant 12" plate we have the kit # SP64FR74 which comes with 2 pads for 10" plates and 2 pads for 12" plates.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Replacement Pad for SnapPad Jack Stand Pad System - 10" Round Jack Foot
- RV Jack Pads
- 10 Inch Jack Foot
- 1 Jack Pad
- Round Foot
- SnapPad Pad System
- Permanent
- Black
- SnapPad
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Can BTBRV Trailer Jack Foot Scale Permanently Remain On Trailer Jack
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Q&A: Looking For A Replacement Converter For My PD9260C That Can Handle Lithium Batteries
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Will The Longview Towing Mirrors Cover My Camera on a 2024 Chevrolet Silverado 1500
- Q&A: Can the BAKflip MX4 Tonneau Cover be Used W/ a Gooseneck Hitch
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Q&A: Adapter to be Able to Use Additional Propane Tank and Appliance with RV Propane Setup
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today


