How to Connect to Bluetooth Speakers of Keystone Camper
Updated 03/30/2025 | Published 04/21/2024 >
Question:
I have a keystone 28rkd. I have two outdoor Bluetooth speakers that I can figure out how to connect to them. There is no receiver in the camper and Bluetooth does not show up on my phone. What am I doing wrong here.
asked by: Mike S
Expert Reply:
Hey Mike, so I found some online Keystone manuals that detail how to link to the Bluetooth speakers.
1. Power on each Keystone by pressing their power buttons. You will hear "Power On" for confirmation. *2. The speakers will automatically, wirelessly link for stereo sound. The speakers will search for each other while playing an intermittent tone. Once the stereo pair is success fully linked, you will hear "Pairing successful, connected" followed by "Left channel" and "Right channel" on the respective speakers. *This process may take up to 2 minutes the first time two speakers are linked. Speakers that were previously linked will relink automatically in a few seconds if powered on in range of one another. Note: Keystone speakers should be within 30 ft. (9 m) of each other to Link properly.3. When the stereo link is confirmed by the solid green LED, press the Bluetooth Connect button on either speaker or the included remote to enter Bluetooth Pairing Mode. Note: The Left channel will be the "master" speaker, and the unit from which the Bluetooth range will be determined.4. On your Bluetooth device, navigate to your Bluetooth settings menu, find Keystone, and connect. Once the Bluetooth connection is made, the blue LED will be solid. You will hear "Connected" for confirmation. *Note: If you experience trouble in connecting, select "Forget this Device" for Keystone onyour Bluetooth device and try to connect again.5. If your Bluetooth device is not able to connect to Keystone, hold the Bluetooth Connect button on the speaker to break previous Bluetooth connections and reset the Bluetooth module.
Continue Researching
- Shop: Suspension Enhancement
- Shop: Towing Mirrors
- Shop: Air Lift LoadLifter 5000 Air Helper Springs - Rear Axle
- Shop: CIPA Custom Towing Mirrors - Slip On - Driver Side and Passenger Side
- Shop: K-Source Snap & Zap Custom Towing Mirrors - Snap On - Driver and Passenger Side
- Q&A: How Does the Drive RV Bluetooth Speaker Connect to a Mobile Device?
- Shop: Furrion Over the Range RV Convection Microwave - 900 Watts - 1.5 Cu Ft - Stainless Steel
- Shop: Bottom Rail Trim for Enclosed Trailer - 93-1/2" Long x 3" Wide - Aluminum
- Shop: Flat Rub Rail Trim for Enclosed Trailer - 1-1/2" Tall x 1/4" Deep - Aluminum
- Shop: Brake Controller
- Q&A: Can I Use Air Lift Springs on 2003 Dodge Ram 1500 With 2-Inch Lift?
- Shop: 12V PWM Filter for RV Backup Camera Systems - Hardwire
- Search Results: weight distribution hitch
- Q&A: Brake Controller Plug Location for 2020 Chevy Silverado 1500
- Q&A: Where is the Brake Controller Plug on my 2019 Chevrolet Silverado 1500 LD
- Search Results: trailer tongue lock
- Shop: Wheel Liners
- Shop: Wheel Well Guards
- Q&A: No Signal And PWM Fix For Furrion Vision S Camera System Connected To 2022 GMC
- Search Results: register
- Search Results: inner dome
- Search Results: skylight
- Video: Curt TruTrack Weight Distribution System Install - 2021 K-Z Connect Travel Trailer
- Search Results: curt weight distribution hitch
- Video: DIY Install: K-Source Snap & Zap Custom Towing Mirrors on your 2020 Chevrolet Silverado 1500
- Video: Installation: Longview Custom Towing Mirrors on a 2020 Chevrolet Silverado 1500
- Search Results: etbc7
- Shop: RV Exterior Lighting

Alyssa K.
5/31/2024
I have a Keystone Springdale 291BRC & I’m having the same issues. It’s just 2 speakers in the outside of my RV nowhere to “turn them on” and no motherboard to connect them from. I’ve turned on my Bluetooth from my phone, & nothing pops up to give me to option to connect?