Can The Roof Of a 2018 Lincoln Navigator Support 300LBS Of Cargo?
Updated 03/19/2024 | Published 03/08/2024 >
Question:
I have a 2018 Lincoln Navigator L with the original factory flush side rails, and I need to carry 300 lbs - since these are rated for 220 lbs, can I add a third one and increase it to 330 lbs?
asked by: Devin
Expert Reply:
According to the owners manual for your 2018 Lincoln Navigator L it appears the maximum roof capacity with a sunroof is 125lbs and without a sunroof is 200lbs. So there is no way you would be able to carry 300lbs on your roof without risking damage to the roof. While the Rhino-Rack Roof Rack for Factory Tracks # Y02-480B-NT are rated up to 220lbs you cannot exceed the capacity given from the vehicle manufacturer even if you used 3 crossbars. If you can tell me what you are looking to carry I can help you determine the best way to carry it with your Navigator?
Product Page this Question was Asked From
Rhino-Rack Roof Rack for Factory Tracks - 2 Sportz Bar Crossbars - Black - 54" Bars
- Roof Rack
- Crossbar Rack
- Aero Bars
- 54 Inch Bar
- 2 Bars
- Overhang
- Black
- Rhino Rack
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Will Rhino Rack Roof Rack for Roof Channels Fit Leer Roof Tracks
- Q&A: What Axle Can I Use to Replace Dexter Axle DEX 5886681?
- Q&A: What Rack System Can I Use On My 2002 Ford Excursion With Factory Side Tracks
- Q&A: Replacement Roof Rack Solution for Thule Tracker II Foot Pack 430 Needing Replacement Part
- Article: Roof Rack Information
- Q&A: Recommended Crossbars and Feet for a LEER Camper Shell with Thule Tracks
- Q&A: Roof Rack for A.R.E. Camper Shell on GMC Canyon
- Q&A: Will the Rhino-Rack Roof Rack for Thule and Yakima Tracks Fit Rhino-Rack Tracks?
- Article: How to Install a Roof Rack
- Article: Where to Position the Trailer Axle?
- Article: Rooftop Cargo Carriers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com


Devin D.
3/8/2024
Hi Bud, I appreciate your response and time - I have product in long slender boxes that are 100" long by 5" wide and 3" tall at 15 pounds each, and we need about 16 on hand at any time during our work day. I thought to construct a pvc board box to hold them at 4 x 4 high or 8 x 2 high, if the roof racks are wide enough for that second One...