Winch Wiring Kit Recommendation for Badlands Winch at Rear of 2006 Mercury Mountaineer
Published 01/15/2024
Products Featured in This Question
Question:
I have a 9500 lb badlands winch and a receiver mount. I want to power it from the rear of my mercury mountaineer. What do I need?
asked by: David B
Expert Reply:
The wiring kit you are going to need to go with is one that has a thick enough gauge to provide the amperage requirements of your winch and also has a long enough length to make it from your battery to the rear of the vehicle.
Since I looked up the overall length of your 2006 Mercury Mountaineer and found that it's right at 16 foot I would recommend the Bulldog winch wiring kit part # BDW20043 which is 3 gauge and 16 foot in overall length.
Product Page this Question was Asked From
Bulldog Winch Wiring Kit for ATV/UTV Winches - 120" Long Power Lead
- Accessories and Parts
- Electric Winch
- Wiring
- Wiring Kits
- 10 Feet Long
- 6 Gauge Wire
- Bulldog Winch
more information >
Continue Researching
- Q&A: Can Winch be Powered by 7-Way
- Q&A: Recommended Electric Plow Winch for SnowSport HD and LT Utility Snowplows
- Article: Trailer Wiring Diagrams
- Q&A: What Gauge Wiring is Needed for Badlands 3500 ZXR ATV Winch
- Q&A: Recommended SumoSprings for a 2021 Ram 1500 Pulling a Travel Trailer
- Q&A: Powering Trailer Mounted Winch from 7-Way Trailer Connector
- Article: How to Wire an Electric Winch
- Q&A: What is Bracket Height for etrailer 2 Swivel Jacks e34RV and e94RV
- Q&A: Extended and Retracted Dimensions of the etrailer 2 Swivel Jacks w/ Bolt-On Mounting Plates
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Determining Trailer Tongue Weight
- Article: How to Change a Trailer Tire