Can Tuson DirecLink Brake Controller 335DL-100 Install on 2016 Volvo VNL780

Question

Question:

2016 vnl780, does it require a special adapter for any portion of the installation? Does the factory wiring in the Volvo harness include electric brake capability?

asked by: Randy

0

Expert Reply:

I don't believe a 2016 Volvo VNL780 has electric brake wiring since they are setup for the air brakes of a semi truck trailer but the Tuson DirecLink Base Model Trailer Brake Controller # 335DL-100 can still be used as long as it has a 12 volt electrical system. You'd just need to hardwire the controller to the truck using it's included universal wiring harness.

The white wire goes to ground, black to 12 volt power, red to a stoplight circuit (typically at the brake pedal switch), and blue to the trailer wiring connector circuit for the brake output circuit.

expert reply by: Jameson C

0

Randy H.

5/23/2024

I asked a question about installing the electric brake controller in my vnl Volvo. A more direct question would be: is there a wire harness connector that plugs into the diagnostic port such as ob2 to pick-up progressive braking signals?

Reply

Jameson C.

5/23/2024

@RandyH It doesn't look like your VNL780 has an OBD2 port and instead has a 9 pin J1939 which this specific controller does not have ability to connect to.

Reply

Randy H.

5/23/2024

@JamesonC So if that's the case, do you sell a brake controller that has the correct adapter?

Reply

Jameson C.

5/23/2024

@RandyH We don't have anything that can connect to the computer of your vehicle to detect the brake output so best option would be a brake controller like the P2 part # 90885 which has an internal inertia sensor that can detect how hard to apply the trailer brakes.

Reply

See All (5) Replies to Randy H. ∨

Answer 1

Hey Donnie! The only thing we would have is the Tuson Heavy Duty Truck Module Kit for DirecLink Brake Controller item #335HDCON-9PIN, which it sounds like you already have. This one is specifically designed for the Volvo semi's. It works with the…

view full answer...

Answer 2

Hey Ray, thanks for reaching out! The Tuson DirecLink Base Model Trailer Brake Controller #335DL-100 can definitely be used with your 2005 Freightliner Century Class either by splicing in the wiring or using one of the following adapters if they…

view full answer...

Answer 3

Since even semi trucks like what you have use OBDII connectors the Tuson DirecLink Base Model Trailer Brake Controller #335DL-100 that you referenced can be used. The module of this is what interprets the brake signal from your tow vehicle and…

view full answer...

Answer 4

For your 2009 Volvo 780 I recommend the Tuson DirecLink Base Model Trailer Brake Controller - 1 to 4 Axles - Proportional #335DL-100 which will be able to control up to 4 axles with brake assemblies. The correct Tuson Heavy Duty Truck Module Kit for…

view full answer...

Answer 5

Just to make sure I am understanding correctly, you are getting the correct signals on the black, blue, red, and white wires on the Tuson DirecLink, like the Base Model #335DL-100, but when you connect your trailer to your 2009 Freightliner it…

view full answer...

Answer 6

The Tuson DirecLink Base Model Trailer Brake Controller - 1 to 4 Axles - Proportional #335DL-100 you were looking at for your 2013 Freightliner M2 112 pulling a Kaufman Wedge Car Hauler will be perfect. The 335DL-200NE you were looking at has…

view full answer...

Answer 7

The best way so hookup a P3 #90195 to a Volvo semi is to wire the semi with its own separate 7 blade connector. For that you can use the Tekonsha #119250KIT and the Universal Install Kit #ETBC7. This will include all of the components needed to wire…

view full answer...

Answer 8

It sounds like the red wire that is coming from the brake switch to the brake controller could be hooked up to the wrong circuit. Use The Hook Probe Circuit Tester #PTW2993, to find the wire coming out of the back of the brake pedal switch under the…

view full answer...

Answer 9

I may have a solution for you, but I checked our resources and we're not showing any brake controller adapters available to install a brake controller on the 2011 Freightliner M2 chassis. In all likelihood if there is a plug in for a brake…

view full answer...

Answer 10

Heavy duty semi tractors like the International Prostar don't typically use standard OBDII ports. Therefore, in order to use the Tuson DirecLink Base Model Trailer Brake Controller part #335DL-100 you'll need an adapter like the Tuson Heavy…

view full answer...

Answer 11

Yes, the Tuson DirecLink Base Model Trailer Brake Controller #335DL-100 will work well for a 40 foot trailer that is equipped with 2 axles. This unit is compatible with trailers that have up to 4 axles (8 total brake assemblies). The DirecLink will…

view full answer...

Answer 12

On a 7 pin round which is the common connection on a semi trailer, the clearance/marker lights are at the 10 o clock position when you look at the trailer wiring connection. When looking at the connector on the back of the truck, that will put the…

view full answer...

Can Tuson DirecLink Brake Controller 335DL-100 Install on 2016 Volvo VNL780

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching