Troubleshooting Trailer Wiring 4-Way Where Running Lights Don't Work
Published 01/03/2024
Products Featured in This Question
Question:
I bought a C56273 4-pin wiring harness for my 2016 Ford Focus and it worked great after installation. Recently though, my running/taillights do not light up, but the brake and both turn signals work. I checked the wires of the harness and there doesnt appear to be any damage to them. Do you have insight into what could be the cause of this issue?
asked by: Dylan K
Expert Reply:
First thing to try is clean the pins of the 4-way on your Focus and trailer. Most likely it's just a bit of corrosion that needs to be cleaned off that's preventing the circuit from being connected. Typically sandpaper takes care of this the easiest.
To test the converter box you can use a circuit tester like the part # PTW2993 to test for voltage going into the box and coming out with the running lights are on as well.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does Power Wire of Curt Trailer Wiring Harness for 2017 Ford Focus RS Hatch Have to Run to Battery
- Q&A: Recommended Hitch for a 2017 Ford Focus RS Hatchback
- Q&A: Will Curt T-Connector Fit 2015 Ford Focus ST Hatchback
- Q&A: Will Curt Trailer Hitch Fit 2013 Ford Focus ST With Center Exhaust
- Q&A: What Trailer Wiring do I Need for My 2017 Ford Focus ST Hatchback?
- Q&A: Trailer Hitch Receiver For 2017 Ford Focus ST Hatchback With Dual Center Exhaust
- Q&A: Can You Dinghy Tow A 2015 Ford Focus
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Flat Towing Package for 2016-2018 Ford Focus